Filling loop with gauge

[Dan Masey]

Can't seem to fine any local suppliers that stock this type of filling loop. I want to fit a remote one in my airing cupboard as the boiler is in the loft. Anyone know of somewhere that may stock them....??

 

[Centralheatking]

Hi Jan,

I can see where your coming from - in fact I have just what you want downstairs
in my workshop - later on I will go and get it and get the specification and post back.
PM me on here at centralheatking

I presume you are one of the 64% of combi owners in this country who experience
'pressure loss' and that is why you want a convenient visual check.

API 2006 (us lot) specialise in this problem and have a device WRAS app &
Patented etc which solves your problem - which you share with 64% of over 12m
combi boiler owners/operators in UK.

centralheatking

 

[diamondgas]

Is this what you're looking for? FL 110 Filling Loop Part L Compliance 🙂

 

[tamz]

Altecnic make them. Sold by most merchants.
Filling Loops for sealed system - altecnic | reflex

 

[Centralheatking]

Dont think so diamond - there is a port on some non rtn valves which is threaded to take a pressure gauge - I have loads d/stairs when I have finished up here will go get it CHk

Is this what you're looking for? FL 110 Filling Loop Part L Compliance 🙂

 

[tamz]

Btw if you are thinking a gauge fits in where the plastic cap is, it doesn't. That is the test point for the dc valve.

 

[Simon F]

you will have to make something up to fit the valve, as in picture

https://www.google.co.uk/search?q=f...xICIBg&sqi=2&ved=0CAcQ_AUoAQ&biw=1290&bih=898

 

[diamondgas]

Dont think so diamond -

I didn't read the ops post fully and you're right regards it not being suitable to accept a gauge. 🙂 I'd do as Simon F says and fit a separate gauge after the loop personally 🙂

 

[Dan Masey]

So what want doesn't actually exist?

 

[erpkid]

You just need a fitting with a 1/4 inch bsp female to accept a gauge. I have made these up in the past using a tap but I am sure BES have them. I just need to justify the lathes to the wife.........

 

[Centralheatking]

Hi Dan - what you want is dead easy its just i am busy right now and really want to help you

msg me at centralheatking on here and I will provide the info as soon as

Centralheatking

So what want doesn't actually exist?

 

[Ermintrude]

Modify part A expansion vessel filling loop .

 

[Dan Masey]

Thanks for the replies, yep I've used a 22mm tee with a 1/2 female then 1/4 bush. Just looks naff.