HALL of SHAME PHOTo`s

[Old Account]

Never seen an unvented cylinder installed outside before

View attachment 29304

Oh and that is the cold main running around the wall 🙂

I like the insulation Folie 🙂

 

[Crinkmeister]

It's fine, that plastic sheet will protect it!! 😀

 

[ShaunCorbs]

saw this on another forum

 

[Leo21]

Don't know what's worse, someone fitting an Ariston, or someone that couldn't be arsed to cut the flue.

 

[spanner]

Could have done with an Ariston flue kit
Then..
He's not got a gradual fall from boiler housing.
All condense must be weeping from flu outlet spigot

 

[Sparkgap]

Don't know what's worse, someone fitting an Ariston, or someone that couldn't be arsed to cut the flue.

Hey! Perhaps he's undersized the boiler and now has to slap 18" of external insulation to get the house warm again! 😀

 

[Ric2013]

Gravity solar pre-heat to cylinder feed cistern (lid removed for clarity). (No vent as such from solar, but very small low-power design, so no risk of boiling). Vent from DHW cylinder is 1/2" copper into side of cistern. Draw-off to cylinder is from the bottom (coldest part) of pre-warmed feed cistern. Ballcock is on far side so literally impossible to get access to replace washer. Plastic CWSC hung on wires through ceiling from scaffold poles above ceiling. Improvised overflow hopper made from washing-up bottle. This photo doesn't do the installation justice, but it's a start.

 

[ShaunCorbs]

Just spotted this

Rate my work @rpm

 

[rpm]

Just spotted this

Rate my work @rpm

View attachment 30733

Guess the fact that you directed the photo my way means it is to do with macerators therefore I see six (?) individual discharge pipes where one would do. Unless there are other reasons that can`t be seen of course. 🙄

 

[ShaunCorbs]

Guess the fact that you directed the photo my way means it is to do with macerators therefore I see six (?) individual discharge pipes where one would do. Unless there are other reasons that can`t be seen of course. 🙄

6 mas yes

 

[1Steven]

Just spotted this

Rate my work @rpm

View attachment 30733

Where in the world is that

 

[ShaunCorbs]

Where in the world is that

Never asked and don't want to know lol

 

[deg]

Anyone for spaghetti

 

[1Steven]

Anyone for spaghetti

View attachment 30914

Make you wonder what they are thinking about when they churn this out?

 

[ShaunCorbs]

😀

 

[Harvest Fields]

😀

View attachment 31057

Builders😡😡

 

[ShaunCorbs]

Builders😡😡

Diyers 😀

 

[Ric2013]

Well, it's only the dry part of the stack. But why?! Agreed: probably DIY.

 

[ShaunCorbs]

Well, it's only the dry part of the stack. But why?! Agreed: probably DIY.

Who needs plumbers costing 300-400 when I can do it myself for a 100

😀

 

[1Steven]

Did it pass an air test?

 

[ShaunCorbs]

Did it pass an air test?

Don't have a clue mate

 

[tolly]

 

[Harvest Fields]

View attachment 31321

Lovely install that😛😛

 

[ShaunCorbs]

It's not that bad only took me an hour and yes I ran out of lagging

 

[Resteros]

Gate valve on Mains no double check valve although there may be a dble check valve on incoming mains and check valve in bib tap...brum.