Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

View the thread, titled "manifold parts" which is posted in UK Plumbers Forums on UK Plumbers Forums.

Status
Not open for further replies.
L

lukio_3

Hi there,

1st post so be kind....🙂

I'm trying to source the parts for, and build a venturi vacuum press as described on the site 'joewoodworker'.

The picture i've attached is of the manifold system required for the system. The guy who made this is american, and so, all the parts are american, imperial and have names that do not match up to fittings and parts on uk plumbing supplies websites such as screwfix.

So.. does anybody know the uk equivalent of these parts? I'm trying to build a setup like that of the picture.

The only part I could find on screwfix was the brass hex nipple!

Any comments or replies welcome

Thanks

Luke
 

Attachments

  • parts.JPG
the bit i would struggle with is the vacuum valve?

the other bits should be obtainable but may be male in stead of female and vice versa and will likely all be metric
 
Couldn't you just use a gas certified ball valve but if it has a polarity reverse it because you are dealing with negative pressure rather than positive?
Pegler do some isolation valves that screwfix state are good for gas steam water and oil. Surly that would do?

-Orangepeel
 
Have a look at Pipeline center web should get uk equivalent from them or BSS
 
take that picture into a decent independant plumbers merchants and they will give you everything that you need, you might struggle with those barb type hose connector things, you might get those from a firm that deals with air hoses, pirtek, jansons etc.
BTtw whats this vacuum press going to be used for, will it involve one of those leather gimp masks and those red rubber ball things that gags your mouth?.
 
Last edited by a moderator:
take that picture into a decent independant plumbers merchants and they will give you everything that you need, you might struggle with those barb type hose connector things, you might get those from a firm that deals with air hoses, pirtek, jansons etc.
BTtw whats this vacuum press going to be used for, will it involve one of those leather gimp masks and those red rubber ball things that gags your mouth?.

No you don,t use vacuum with them you use..........oh oh!😱
 
Status
Not open for further replies.

Official Sponsors of Plumbers Talk

Reply to the thread, titled "manifold parts" which is posted in UK Plumbers Forums on Plumbers Forums.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Weekly or Monthly Email Digest

Back
Top