Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

will this work

View the thread, titled "will this work" which is posted in Gaining Plumbing Experience on UK Plumbers Forums.

J

jesijoe

hi new to forums so ihope i dont mess this up- here goes
in the attached is a(rough) drawing of a dual ch system.the house is about 1800 sq ftand about 50 ft long with hot press in the middle. the boiler is pretty big 120000btu output the bb hasnot been sized yet(but mid to large size i expect)
i want this system as simple as possible so its a tmeclock for oilside and pipestat for bb with on off valves for hot water and heating
Have i missed anything ?
is there any fatal flaws?
do i need a seperate f+e for th oil side?
could i bring the bb f+e into the hot press or leave it where it is?
would the feed from bb be better going thru attic (its a bungalow -no upstairs only attic)and drop into hot press(for gravity reasons if power goes)?
wold atowel rail be large enough for a heat sink?
hop i havnt forgot anything
any of your comments/suggestions/improvements would be greatly appreciated
 

Attachments

  • Untitled.jpg
    Untitled.jpg
    55 KB · Views: 37

Official Sponsors of Plumbers Talk

Reply to the thread, titled "will this work" which is posted in Gaining Plumbing Experience on Plumbers Forums.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Sponsors

Thread statistics

Created
jesijoe,
Replies
0
Views
1,727
Back
Top