Search the forum,

Discuss baxi 105e in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

hammers4spanner

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
7,712
went to a baxi today customer complaints of a noise within the boiler whenever its being used , went there had a listen and its an intermitent wooshing noise every minute or so and goes again then a whossh noise through the boiler and gone again .
this happens on heating mainly but on accasion hot water as well
any ideas guys??
 
If you can hear any noises that sound like Chris Moyles - put some noise silencer in it!
 
What's the burner doing whilst this wooshing's going on H4S? If it's happening on both water and heating try turning the stats down, see if that makes any difference/ You could also check BP's on Modulation ?
 
Do a BG tell her parts no longer available and sell her a new boiler !
 
Do a BG tell her parts no longer available and sell her a new boiler !

To be honest i have suggested that as its prob about ten years old and by the state over it never been serviced and as for the wooshing it actually does sound like the tide on the beach .

Take it from responses tho nobody knows
 
Take it from responses tho nobody knows

Personally need a tad more info H4S hence the questioning around heat (post5) ... maybe modulation probs overheating the main heatex? Main flame up and down with the tide so to speak :)
 
To be honest i have suggested that as its prob about ten years old and by the state over it never been serviced and as for the wooshing it actually does sound like the tide on the beach .

Take it from responses tho nobody knows
start with a service that would cure a lot of noises BTW 10 years is not old for a 105e
 
air in the system,re pressure just below blow off (3 bar) and run and bleed...maybe,and dont forget to bring pressure down before you go....
 
Status
Not open for further replies.

Reply to baxi 105e in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
120
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
223
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
249
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
321
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock