Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Danfloss wireless thermometer and receiver in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Ana

Messages
12
i have set the thermostat but the receiver doesn’t kick in. If press the Ch button it comes on then off. So I don’t have any heating

If I put the programmer on constant heating. I still don’t have any heating.

Any help much appreciated
 
Quite possible that the thermostat is fubar. Is there an override button on the receiver?
 
Receiver could also be faulty if you are pressing button on it and it goes on and then off in a couple seconds
 

Reply to Danfloss wireless thermometer and receiver in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
386
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
209
I have an ideal vogue max S18 boiler and I’m considering fitting auto balancing TRVs, my question relates to the boilers pump. I see a boiler...
Replies
1
Views
186
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
282
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
543
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock