Grundfos MLE 132E speed control

[Earmic]

Yes that’s the device use your phone and the grundfos go app

Update. We got the ir to work and it controls everything the front display does but like was stated it got the "normal" control mode to work, what happens is the pump normally shows stop, then when you push the start/stop button, the mode changes from stop to normal and you would expect the pump to start however it doesn't, it just sits there in normal mode.

 

[ShaunCorbs]

So you can see all the settings on your phone etc and make changes / set things ?

 

[Earmic]

So you can see all the settings on your phone etc and make changes / set things ?

Yes, it appears the IR is the same as the front display (so far). We can change, set, adjust.

 

[ShaunCorbs]

Front display? That’s yours as that’s the 132e

 

[John.g]

Presume constant pressure control is available in all versions of the above?.

 

[Earmic]

Presume constant pressure control is available in all versions of the above?.

Its an MLE132E with display. We also have one like the photo, but that is next.

 

[ShaunCorbs]

I see on the pump you should be able to see a pressure when it’s running correct ?

 

[Earmic]

I see on the pump you should be able to see a pressure when it’s running correct ?

Yes we can see monitored (controlled, discharge) pressure, setpoint, speed, etc. but the pump wont run when started.

 

[ShaunCorbs]

Are these figures on 0 when not running / off ?

 

[Earmic]

Are these figures on 0 when not running / off ?

What figures?