Search the forum,

Discuss How difficult is it to remove this?! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

BD1978

Doing up the bathroom and discovered this boxed in. How easy is it to remove? Guessing it's the original waste water pipe system. It's an eye sore and takes up space. Is it a complex job to remove it and install a smaller neater alternative?
pipe pic.jpeg
 
that's your main 100mm (4") drain cast iron even if you manage to remove the iron branch you will still have the same size but in modern plastic , is this on ground floor because that cast iron will go down to ground level, and will require special tool to cut into it not something for DIY I'm afraid
 
that's your main 100mm (4") drain cast iron even if you manage to remove the iron branch you will still have the same size but in modern plastic , is this on ground floor because that cast iron will go down to ground level, and will require special tool to cut into it not something for DIY I'm afraid
Thanks. It's on the first floor so from your guidance I guess it runs down through the house to a drain. Thanks for the info.
 
that's your main 100mm (4") drain cast iron even if you manage to remove the iron branch you will still have the same size but in modern plastic , is this on ground floor because that cast iron will go down to ground level, and will require special tool to cut into it not something for DIY I'm afraid
Would this pipe normally be on the outside of the house or is it common for them to run internally?
 
Yes it would, at sometime in the past its gone straight up through the roof it may be possible to install a new external soil system but that would be expensive
 
That is beautiful. Back from the days when plumbing was built to last. Wish my house had such a nice soil and vent pipe.

I bet the gasket on that inspection/rodding eye is a greased felt material, and I bet those bolts will still unscrew after all those years (if you use a ring spanner and some care). The wall of that cast-iron pipe is probably half an inch thick, deadens the sound of running water and will continue to give good service until it rusts through in another 5o years or so.

The plastic pipes inserted into it are probably a recent modification (defacement).

As others have said, if that is your bathroom, the pipe will be needed somewhere. You could put a new one in, but you can't do without one, assuming you want a flush toilet.
 
Status
Not open for further replies.

Reply to How difficult is it to remove this?! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
7
Views
294
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
268
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
291
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
375
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock