Notching and drilling joists

[Liz Knowles]

Does anyone find notching joists a complete pain and are there any products out there that are an alternative or any other ways of hiding pipework?

 

[Bartdude]

No way around it unless you want to run all pipework on the surface!

A cordless circular saw,a Fein Multimaster and good quality spade bits will make it easier.

 

[Liz Knowles]

No way around it unless you want to run all pipework on the surface!

A cordless circular saw,a Fein Multimaster and good quality spade bits will make it easier.

Thanks - are there any products for clipping pipes to joists that you know of?

 

[Bartdude]

How about this?

 

[stevetheplumber]

How about this?

View attachment 1909

always put the nail under the pipe as they can drop out with age and heat the other way

 

[moony]

angled drill for drilling joists is a god send too

 

[oldplumber]

get an apprentice! SAVES ON THE KNEEES

 

[Blackcatgas]

Its par for the course, I just get on with it.

 

[tamz]

You could use one of these
[DLMURL="http://www.visualart.ro/test/details.php?image_id=764&sessionid=9a8648e0eae6bb4aeba489863e2aeb11"]VisualART - Gallery[/DLMURL]

If not it would always be handy in the fight against the cowboys

 

[Liz Knowles]

Long time since I have been on here...
When I asked the question, I was thinking more of how you secure a pipe in a notched joist or a joist which you have drilled. I know a saddle clip can be used in a notch but obviously you need to make the notch big enough to accomodate the clip. How would you do it if the notch had to be narrow or if a pipe was passing through a hole made in the joist?

 

[Dotty]

Nail in pipe clip as was shown earlier in this thread Liz.

Welcome back!

 

[Mike Jackson]

I use a bit of hairy felt to stop the pipe rubbing and rely on gravity in holes. In the past I've seen clips designed specifically for securing pipes in notches. An alternative is a clip fixed to a bit of batten secured to the side of the joist.

 

[Liz Knowles]

Nail in pipe clip as was shown earlier in this thread Liz.

Welcome back!

how would you use that to secure a pipe passing through holes?

 

[goz666]

I have these for drilling joists with a 240v angled head drill, these wont work with a battery drill.....well, not any that I've tried.

Speedbor MAX Speed Bit Sets - Tools - IRWIN TOOLS

 

[Liz Knowles]

I have these for drilling joists with a 240v angled head drill, these wont work with a battery drill.....well, not any that I've tried.

Speedbor MAX Speed Bit Sets - Tools - IRWIN TOOLS

its not drilling the hole i am on about, it is securing pipework in place