Search the forum,

Discuss Sealed system powerflushed and balanced. Not working in the Plumbing Jobs | The Job-board area at PlumbersForums.net

armyash

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
2,653
I'm going to look at a job tonight, Customer called yesterday and said she has had it powerflushed and rebalanced but the heating does not work. She said sometimes one or two rads will warm up sometimes nothing.

She said she has added a couple of rads to the system.

Apparently someone has told her she needs a second pump on the system. I asked her if any pump had been changed during powerflush or balancing she said no.

I'm thinking possible dodgy pump, she lives on a newish build estate so I'd be surprised if the system is sludged up already. But then I'm sure a lot of this estate is microbore.

I can't assume the power flush and balancing was done correctly so I can check this. Other than pump what would you be checking for? I'll check diverter also.
Thanks
 
I would check pump first, unlikely all the rads are blocked up solid
 
Apologies for the delay.

Turns out the customers son and husband are plumbers. They had powerflushed it themselves. A lot of microbore.

Apparently they had a company come in and balance the system. I didn't believe them.

Its a town house. Some rads on the top floor work, some don't. S plan. Did seem as though it was a balancing issue (that's where I would have started.

Didn't fancy the job, politely declined.

Just got the feeling they wanted me to tell them what was wrong and would have moaned at the price. Wasn't worth the hassle but thank you for the replies.
 

Reply to Sealed system powerflushed and balanced. Not working in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
235
P
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock