Search the forum,

Shower runner

Post new thread

Discuss Shower runner in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

bloomruss

Hello

I have recently moved into a new property and the shower door runner has broken, I don't know the make or when it was installed, I have attached a photo, can anyone advise

Thanks WP_000238.jpg
 
Status
Not open for further replies.

Reply to Shower runner in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
179
Lou
Lou
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
225
ShaunCorbs
ShaunCorbs
S
Porcelanosa KRION Attica screen 1.2m, anyone?
I have a brand new, unboxed shower/wet room screen from KRION purchased from Porcelanosa UK. It is the Attica 1 model, as shown in the attached picture from their catalogue. Like on this image ->...
Replies
0
Views
102
Sebastian T
S
D
Pop quiz, does anyone recognise this radiator valve?
Hi Does anyone recognise the make/brand of the radiator valve. It leaks when closed and Iam hoping I can replace a seal etc?
Replies
4
Views
209
turnpin
turnpin
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
237
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Cutters
Tiling Forum UK
Electrical Advice | Electricians Blog
Electrician Talk Forum
Plumbing Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock