Search the forum,

Discuss Sound when closing taps and flushing toilets returns after emptying system in the USA area at PlumbersForums.net

Messages
2
Hi All,

I really need some advice on a home plumbing issue please.

We have a sound when closing taps and flushing toilets that started a few months ago.

I have tried many times to empty the system by closing off the mains inlet stopcock, opening all the taps, flushing the toilets, etc then closing them all, refilling the system, and finally opening the taps from the bottom of the house to the top to blow out the air. The sound disappears for a few days, but comes back.

It starts lower down in the house and taps and moves upstairs where the noise is very prominent after the flush on the toilet on the top floor.

This started after we had some work done on our boiler, but that doesn't have any issues.

Any ideas? Am I missing something when draining the system or refilling it?

Thanks,

Steven
 

Reply to Sound when closing taps and flushing toilets returns after emptying system in the USA area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
137
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
1
Views
95
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
324
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
245
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock