Search the forum,

spillage in 0ven = burners now partially blocked.

Post new thread

Discuss spillage in 0ven = burners now partially blocked. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
F

fizzyj

:(when using the oven yesterday a shelf got pushed back and some pies fell over the back and fell onto the burners causing a blockage. managed to get ignition working again but not all holes working and all not working at high heat settings. What can be done to get the burners working again?
 
Last edited by a moderator:
Burners out for a good clean up. Not an user/operators job.
 
Status
Not open for further replies.

Reply to spillage in 0ven = burners now partially blocked. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
355
Chuck
C
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
534
Chuck
C
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
275
exedon2
exedon2
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
257
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
199
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum UK
UK Tiling Forum
Electrician Talk Forum
TilersForums.co.uk
Tile Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock