Search the forum,

Discuss stop water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

besty

hi there

im trying to cut off the water to the cold water supply in my bathroom, i can cut off the hot supply but i cant get the cold water to completely stop, iv turned off every valve i can find including the one's in the loft( also main stopcock} but there is still a slight flow of water through the pipe can anyone throw me bone
 
turn the tap on downstairs (kitchen) when the water is turned off this will stop any water getting to the bathroom , the stop tap can not be shutting off fully
 
Sounds like your main stopcock isn't shutting off fully -- a very common problem with rarely-used valves!

You can shut off the mains water using the outside water-board stopcock, and you should then have the inside stopcock replaced as soon as possible
 
I think its more likely that the cold to your bathroom is tank fed (from the loft) and one of your valves is letting by a little. If it is tank fed then tie the cold tank ballcock arm up with some string so that the tank cant fill and then drain the tank down by opening the bath and basin cold taps, (dont turn on the hot taps or you will waste a cylinder full of hot water.) Once the tank has drained you should be Ok. Might be worth replacing the dodgy valves while its all drained down.
 
If bathroom cold is tank fed you will need to drain this tank or bung the outlet at bottom of tank, i have used a carrot to do this before. Be careful not to let carrot break off into outlet or you are in deep s**t.
 
thanks alot all of you, i thought it might be that just needed a second oppinion. thanks again
 
Status
Not open for further replies.

Reply to stop water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
153
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
147
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
361
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
254
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
6
Views
235
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock