Discuss Thermostatic shower valve replacement in the DIY Plumbing Forum area at PlumbersForums.net

Messages
1
Hi DIYer here. Trying to replace concealed shower thermostatic valve. Please could you advise on how to remove valve. Very large box spanner? Many thanks
IMG_20230606_202015.jpg
 
Put a large slotted screwdriver in the left hand slot and strike it downwards with a hammer using short sharp blows. You have to have the screwdriver almost vertical, resting on the bottom ledge of the slot.
 

Reply to Thermostatic shower valve replacement in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
282
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
227
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
262
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
227
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The...
Replies
6
Views
276
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock