Discuss uponor ufh thermostats in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
F

fredyflame

Hi
Can I use ant type of thermostat to control the actuators on my uponor ufh I want to use an lcd display one rather than the thumb wheel ones supplied in the kits

Thanks

Tony
 
Yes your spark can wire in any as long as compatable with wiring centre
 
Some old ones are low voltage though so be carefull!
We've retro fitted Honeywell RF programmable stats after cable faults and rubbish electricians, do it is possible dependent on type.
I think all new systems are 240 they phased the others out.
 
Some old ones are low voltage though so be carefull!
We've retro fitted Honeywell RF programmable stats after cable faults and rubbish electricians, do it is possible dependent on type.
I think all new systems are 240 they phased the others out.

Plenty are still low volage
 
So to make the system even more controllable I can use independant progammable thermostats on each room or area alongside my 12 way controller timer and actuators ?
So the timer can set up a basic on or off and these could say for instance program the bedroom only to come on morning and evening?
 
By the way found this site with a link to the guy who wanted to know about moving the air from upstairs on his system. you were all so patient, it is a funny set of posts
 
So to make the system even more controllable I can use independant progammable thermostats on each room or area alongside my 12 way controller timer and actuators ?
So the timer can set up a basic on or off and these could say for instance program the bedroom only to come on morning and evening?

Yes this is the way it is ment to be done anyway
Don't tell me your the same person with a different name lol
 
Status
Not open for further replies.

Reply to uponor ufh thermostats in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
221
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
220
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
322
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
396
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Replies
1
Views
319

Newest Plumbing Threads

Back
Top