Search the forum,

Using Tapatalk on iPad

Post new thread

Discuss Using Tapatalk on iPad in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

TomLane

Can anyone help me out with using Tapatalk HD & the Plumbers forum. Have seen some use this for the forum?!?
 
Soz for being so vague! I knew in my head what I wanted to type but the fingers just were corresponding. I think I have managed to sort it all now. I couldn't find the plumbers forum initially but have since found it. Just need to work my way around the different format & I will be fine. Thank you for the response anyway, much appreciated. Tom
 
To be fair iPads are big enough to browse the forum using the main style.
Failing that, change it to the mobile style (drop down box at the bottom of the forum on the left).

Though I am due to upgrade tapatalk as it's not been done for a few months and there are a couple of small improvements etc I think.
 
Think I prefer to use the forum through Safari Internet, as you say it's big enough to browse the site reasonably well.
 
Status
Not open for further replies.

Reply to Using Tapatalk on iPad in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
111
Lou
Lou
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
286
oz-plumber
O
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
dreikher
dreikher
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
227
DIwhYdidIstartThis
D
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
200
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock