Worcester greenstar 24i junior

[Matt0167]

Hi guys,

Had a call out to a breakdown and the previous engineer had put a secondary prv on the discharge pipe of the main prv instead of replacing the original also fitted a external expansion vessel upside down with the scrhader valve an inch of the floor

I've never had to change the prv on a worcester 24i junior is it easier to take the boiler off the wall / or the block out, ... or is there a simpler way as it's not located in the easiest location

Thanks for you help

Matt

 

[ShaunCorbs]

Yes

You can manage by cutting the cold feed and removing it to gain more access

 

[Matt0167]

Yes

You can manage by cutting the cold feed and removing it to gain more access

Cheers shaun

 

[sammathias]

Optimistic Shaun... Either boiler off the wall, which is easier or take vitrutally every internal component out to get access. terrible design.

 

[Riley]

Plus the obligatory all the skin of your hands trying to get to It Good old Worcester razorblades

 

[EvilDrPorkChop]

You can manage to do them without taking anything out or boiler off wall. Just. As Riley says, you do end up with a few cuts though

 

[Millsy 82]

Optimistic Shaun... Either boiler off the wall, which is easier or take vitrutally every internal component out to get access. terrible design.

A terrible design on a Worcester? Never heard of. I think the factory is full of monkeys to be fair.

 

[Matt0167]

Well I've booked it in for tomorrow, just need to borrow jeremy beadle for an hour to squeeze his hand in behind the pump

 

[Steve weightman]

Either way it's arse of a job and not ending up with a leak afterwards is a miracle

 

[ShaunCorbs]