Discuss Worcester Greenstar Junior 28i combi boiler - no green light or heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
4
Hi all,

First of all, I hope I have posted this in the correct place (apologies if not). I haven't used my boiler throughout the summer and have gone to turn the heating on. The hot water is fine and no problems but the green light does not come on my boiler and there is no heat. The blue light is on as usual and does not flash at all.

I noticed the pressure had dropped and I have therefore repressurised it (it is now between 1.5 and 2 in the green). However still no green light or heating.

I tried holding in the rest button but no luck.

The batteries had run out in the thermostat which I replace (but I don't think that would affect it?!)

Anyone have any other ideas before I call someone out?

Thank you :)
 
As above, depends which thermostat you have but it may need repairing. If the receiver is picking up the thermostat signal then it's time for you to call an gas registered plumber in to check your boiler.
 
Thank you both. Much appreciated. I don't suppose there is any sort of guide on how to pair them available anywhere, is it simple or am I better off calling someone in? I have done a Google job but not much luck.

The Thermostat is a Salus RT500RF (TX).

Thanks again.
[automerge]1570207338[/automerge]
Iv'e managed to do it. I have heating!! Wohooo. Thank you both very much :)
 
Last edited:

Reply to Worcester Greenstar Junior 28i combi boiler - no green light or heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no...
Replies
6
Views
266
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
289
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
283
PSxxxxxx
P
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
325
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
396

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock