Vaillant Plus 831 v Ideal Vogue Logic Plus 40KW v Worcester Si Compact 30 KW

[vern]

My baby boy could do neater pipework, did he have no clips????awful

 

[Rickster123]

Why don't you treat him to a heat mat. It will change his life!

 

[Leo21]

Why don't you treat him to a heat mat. It will change his life!

A what?

 

[Rickster123]

A what?

You northerners use speedfit so it doesn't apply!

 

[naut2k0]

My baby boy could do neater pipework, did he have no clips????awful

Well to be honest its someone who works with him that did the pipe work. There are clips - just not around the boiler ... I'll bring that up when I see them tomorrow ...

I presume with the burns marks on the wall are because I will have it covered up and the kitchen is getting a slight reskim in some areas ...

BUT what's the kindest most polite way to raise this .....

 

[Leo21]

You northerners use speedfit so it doesn't apply!

Hep20, speed fit is to rough even for me.

 

[Ermintrude]

Your fitter is rough! The flue retaing clip isn't on correctly! The black stud in the Center should project through the Center of the white horse shoe! If you can dislodge the horseshoe easily with your hand you are should switch off the appliance and wait for your fitter to fix it.

Is behind the white rubber against the wall filled with cement or plaster?

Ideal give 7 years with logic to accredited installers.

I would rather a logic as vogue not proven and has already had a few hardware updates.... No one wants a duo tec 2!

 

[naut2k0]

Your fitter is rough! The flue retaing clip isn't on correctly! The black stud in the Center should project through the Center of the white horse shoe! If you can dislodge the horseshoe easily with your hand you are should switch off the appliance and wait for your fitter to fix it.

Is behind the white rubber against the wall filled with cement or plaster?

Ideal give 7 years with logic to accredited installers.

I would rather a logic as vogue not proven and has already had a few hardware updates.... No one wants a duo tec 2!

Its plaster then brick work! You were right about the flue retaining clip - it was on, but could easily be removed. I've noticed that it's not straight !!!

Well ... I've already agreed the Vogue ... so fingers crossed its okay .... these hardware updates .... do they have to be done by a qualified fitter, or is that something I can do?

 

[dancinplumba]

There appears to be a check valve only on the ch return filling loop point. Not complying with water regs

 

[naut2k0]

There appears to be a check valve only on the ch return filling loop point. Not complying with water regs

Just to say that they have't finished commissioning the boiler anyway so perhaps this was to be added later? Can you be more specific where this valve should be as I guess they should add one for the new boiler? I'm a novice after all!

Thanks!

 

[Ermintrude]

Check valve is built into the filling loop assembly as supplied by ideal and meets all water regs.

Vogue updates either done in factory or by ideal once registered. Free of charge!

Get Flue clip sorted and turn boiler off until its safe!

It's illegal to leave un commissioned gas appliance connected to gas supply!

 

[naut2k0]

Hey Zebedy, boiler was off and unconnected. The sparky is doing all the electrics now.

So he has found an Ideal Vogue (which was ruddy hard) as they seem in hard demand and Ideal don't like to ship them out via courier as they are getting damaged. It arrives tomorrow.

In the meantime, here are some pics from behind the boiler showing the bracket and the flue (I guess the same flue will work on the Vogue) and the pipework too.

 

[Ermintrude]

Yeh vogue and logic same flue system. Pipe work same at bottom I think.

The daylight coming through behind the bracket is a bit of a problem though. Wall should be made good inside and out. Not permitted to have a vent or penetration within 300mm of a flue.

Get the holes filled then get your self a free gas safe inspection because your fitter is a !!!!

 

[Ermintrude]

Never swapped logic + for a vogue but think vogue is longer is taller from top to bottom. And gas might be 22mm from memory?

 

[Scott_D]

Let's hope the gas supply isn't live back to the meter

 

[Ermintrude]

No one would disregard GSIUR to that extent! Sure meter is capped and temporary cross bonding in place

 

[GasmanxxxR1]

Zebedy, i think your being a little critical of the engineer, let him finish the job before you rip it to shreds, yes it looks rough but he might be fairly new to the game and its not finished yet

 

[Dotty]

Hopefully there is a gsr and it's not the op chancing his arm with us.

Not easy to tell but I'm watching this one see how it pans out!

 

[Leo21]

Zebedy, i think your being a little critical of the engineer, let him finish the job before you rip it to shreds, yes it looks rough but he might be fairly new to the game and its not finished yet

In other words , zebedy. Wind your neck in!

 

[phil the bucket]

Hopefully there is a gsr and it's not the op chancing his arm with us.

Not easy to tell but I'm watching this one see how it pans out!

Exactly what I was thinking croppie