Hi all,
Hope you’re all doing well.
I had a new bathroom installed recently which involved new piping, and also capping off some redundant pipes. Since then, my boiler (pretty new Vaillant combi) turns on when I turn the cold water on. I’ve done some reading and it seems like the problem is...
Hi, I’m having issues with cold water to multiple outlets. Taps, showers, toilets cold water is fine at the kitchen sink. The hot water system is a Glenhill unvented cylinder. Hot water is fine at all outlets. I assumed the cold outlets not working were from the balanced cold from the...
This is doing my head in, so I am turning to the experts here for any wisdom...
In the last couple of days I have very low cold water pressure in my downstairs utility room and downstairs bathroom (they back on to each other). The main cold feed (kitchen tap) is normal pressure. And all the...
If changing a combi boiler system to a heat pump. What do they usually do with the balanced cold connection on the hot water cylinder? Cap it. And put a pressure reducer on the mains so they have equal hot and cold pressures? I can't see them repiping a balanced cold from the cylinder to each...
Hi everyone,
Recently all the water tanks in the attic were disconnected to connect to the mains water supply (mine was already on mains but the other 5 flats in the building needed to be connected to mains water) and the company were also going to fit PRV's and isolation valves to the pipework...
I'm in a house with the cold feed coming up in the kitchen. In 25mm mdpe. The boiler is in the garage adjacent. I plan on running the cold from the sink in the kitchen under the kitchen units to the garage to feed to boiler. And the 15mm coming back from the boiler to the sink. Would there be...
I had my indirect hot water cylinder removed a few days ago and the central heating boiler and pump is turned off at the fuse spur right next to the boiler.
I have been without hot water for a few days which is fine - The plumber left the flow / return to the cylinder uncapped as well as the...
Hi,
We had a Valiant ecoTECplus 938 installed a couple of years ago. The past few months we've noticed it come on with the cold taps rather than just the hot. A plumber came to service it and said this is normal but we don't think it is + it's a waste of valuable gas. I've read up and think it...
I live in an apartment and have a cold water tank in it. The cold water tank feeds the cold water tap in the sink and the bath. Recently, I refurbished my bathroom and, according to the plumber that fitted the new taps, high-pressure taps were fitted. Consequently, the water that comes out of...
Hi,
Recently noticed an issue with thermostatic shower that was determined to get sorted. The shower would drop (which got worse) and would not maintain temperature,due to water quality here and visible limescale in cartridges,decide to just replace entire shower for a nice new one.
This...
I’m doing a bathroom refit, and there’s some strange pipework design that I’d like some advice on, please.
I want to remove the cold water pipe running through the loft space because I would rather avoid having a cold water pipe buried under the loft roll insulation.
Instead, I’d like to reuse...
Hi, I had a Madrid 2 Triton shower, I had it for 6 years then one day it started to run cold, so I purchased a Triton Seville shower and changed them over, that was running great for 3 days and now that has gone freezing cold, any advice? Thank you
Hi, I am reinstating an indirect hot water tank and have 2 cold water feeds coming into it from the same supply. One of the feeds has a float valve but what ever was on the other has been removed. Why would there be 2 feeds to the top of the tank? Can I blank one off and just use the float valve...
I have a caravan with a brand new heating system.The Valliant combi boiler is working fine but one radiator and one towel rail are stone cold.I have bled both and also tried to balance the radiators with no success.Even when I shut off all other radiators the problematic ones still don't heat...
Hi
I fitted a low pressure shower set when I had a low pressure open vented system, which has a very low pressure rating. I now have a combi boiler with good pressure. I was wondering if having a shower set with a too low pressure rating could cause predominantly cold water to come out? The...
Hi.
I have one radiator downstairs that will just not get hot.
If I disconnect the thermostatic valve then turn it on hot water comes through.
When I reconnect it the radiator heats up for a couple of days then stops again.
I have bleed the radiators / balanced.
Any idea?
Thanks
Sorry I have sort of asked this before, tried professionals but not great 1st experience hence DIY attempt attempt again.
2 completely cold rad's, another one get pretty warm, flow pipe hot, return v.luke warm. (Both rad's I have manually flushed really well)
Hot water works fine, boiler return...
I have a new shower that has worked fine, albeit with low hot water pressure, for a couple of months. Now it starts hot, but then goes cold completely, sometimes after a couple of minutes, sometimes after less than 30 seconds.
Meanwhile, on the side of the bathroom sink, there are no issues...
Hi all
We have an issue with a kitchen tap it seems to run hot and cold or Luke warm all the the other taps in the house are fine it’s just this one tap. It is a mixer tap and the combi boiler is about 2 metres away. It’s a Worcester greenstar. Is this an issue with the tap itself or something...
Hi, I wonder if you could help me. The overflow pipe drips intermittently from the large cold water storage tank in the loft. Not the small F and E tank. The ball valve has been checked and is working ok. The vent pipe from the hot water cylinder is not venting any water into the tank, and the...