Heating works fine, hot water works fine. When the heatings been on a while and the tennant runs a tap the boiler locks out.
Circulation issues of some sort is my thoughts? Anyone???
hi all,
I'm really hoping someone here can help. I've just installed a red compact 24 pellet boiler and switched it on for the first time and i get the following alarm code preventing the boiler from even firing for the first time 'A18 water temperature overheating', which obviously makes no...
I'm looking to get my boiler changed in the coming week and everyone seems to have there own opinion with what is a good brand/model and what is a bad one.
On balance I'm getting a good vibe about Intergas, but I'm a bot concerned that the output of the Compact HRE SB 30 boiler is rather low...
I have an Intergas Combi Compact HRE 36/30 (fitted 5 years ago) and despite different Engineers being advised by Intergas UKs technical team I still keep getting f11 faults resulting in no hot water (I have to press reset each time to get hot water again).
23rd January:
Flow switch...
Need to change a plate heat ex on one of these but the screws holding it in place have gone soft and it's just rounding off. Any ideas? It's too tight to get the grips on it and plastic manifold so I've got to be gentle
Looking at the 28 CDi Compact and the 28 Junior, the flow rates, heat outputs and dimensions of the Junior and Compact look almost identical to me so what am I missing? I know the Junor is the bottom of the range, but where is the extra money for the Compact going? I know the Junior didnt used...
Hey guys,
Mate fitted 1 of these boilers, turned it on for the first time and left it to go through its 'pre-heat sequence' however it WILL not come out and it has been running for 24hours when manufacturer instructions state its 15mins.
Customer or gas engineer hasnt ran any taps or got it on...
Our Vokera Compact 24SE shows a red light when the gas is trying to ignite, which it fails to do, and then the red light goes back to green/flashing green a few seconds later when we turn off the hot water tap/heating thermostat.
Before we get an engineer to come and look at it, any ideas as...
Hi chaps.
Just has a Worcester Bosch 28cdi compact installed. All working fine, but found something that's confusing me.
The flow control for the CH apparently can go up to 82.... whilst the DHW can be turned up to 60. User manual tells you this and basically just tell you to 'turn the...
hi guys, I have a saniflo and someone dropped a cloth down it, jammed the motor and fried the printed circuit board, does anyone know where I can get spare parts for it, particularly the pcb?cheers
Just after some friendly advice on what could cause this problem with this not so good boiler
Its the Vokera HE 25 Compact
The heating works fine
The hot water i turn the tap on and its warms up then cools back to cold then 10 - 15 seconds later warms up for 10 seconds and cools back...
I have problem with hot water. Water going hot/cold/hot/cold. Pressure gauge jumping up/down. I have switch only dhwater. When change at dhw & heating automaticly hot water going to radiators. I changed thermisor. What is this problem???
Hi there, does anyone know the maximum amount of radiators this boiler is designed to serve? I was at a house last week and the tenant has 10 radiators in the property and 1 (the furthest away
from the boiler) doesn't heat the same as the rest. It isn't choked and doesn't need bled. If you turn...
I have a Vokera compact 29 that is starting up normally, fan running, aps made,pump running,igniting and firing up but then cutting out a few seconds later with a solid red light and a flashing yellow. Could this be the pilot failing causing the gas valve to close??? Or something else?
Any help...
I have been trying to decide on what boiler to go for - I think my head is about to explode - but I have to make a decision.
Some background - I have a combi boiler - 4 bedroom house with 9 radiators (of varying sizes - 3 big doubles and the rest singles)
My current boiler is an Aristion Clas...
Is there a way to manually reset them after gas being off? Been finding after doing a TT that they specific boilers have took about 15 minutes to fire up afterwards or is that just normal for them?
Hi,
I'm hoping a few people on here can help me as I took the plunge and had a wood pellet boiler installed last year and it's been nothing but trouble since.
In May 2013 I had a company install an MCZ RED365 Compact 18 wood pellet boiler and it has been a nightmare with LOADS of issues. since...
Hoping someone can help!
I have the Glowworm compact 80e boiler and the pressure keeps rising to 3 bar and then the relief valve kicks in, here is what we have tested to rule out so far.
The filling supply/loop is ok, have taken and left this off to check there is no small leak letting...