It's not going above 42 degrees. Burners on. Have checked thermostat and it's working fine. It ramps up every now and temp goes to 65 degrees for about 10 seconds and then ramps straight back down and temp goes back to 42...????
Didn't go as far as to check the thermistor as it was bloody late...
It's not going above 42 degrees. Burners on. Have checked thermostat and it's working fine. It ramps up every now and temp goes to 50 odd and then ramps straight back down and temp goes back to 42...????
Hi I am new to this and not sure how to put up a pic without it saying denied.I am unsure how to connect the nest heat link to this combi. Any advise would be great
can't test the boiler in full rate as when selected it doesn't respond, doesn't respond to anything in the p menu
board fault i presume. going back tomorrow, anyone had this before?
HI everyone
Had my new boiler about 4 months... it's a vaillant ecotec plus 838...
Today I noticed some browning on the white plastic cover looks like could be water marks... or some sort of lacker issue...
Anyone seen something like this before?
Hi i have installed one of these into a large, does this boiler have frost protection built in. or do i need to buy a external stat. If one is built in does it just run its self as long as boiler is on . or does heating hot water have to be on cont on the programer
thanks
Hello all,
I am really hoping for some help and advice on a little predicament i find myself in.
2 years back we moved into the house, i ripped the pre-historic heating system out and with the help of my brother we fitted a new system adopting the 624 with two zones, Upstairs and Down...
Hi
Vaillant have confirmed the Vsmart unit will work with the older 831 Combi.. but the wiring instructions for the ebus do not match the terninals in the boiler. Has anyone fitted a vsmart unit to an 831 combi. What terminals should it be wired to? 3 and 4 without bridge??
Thanks
Bob
How to switch comfort mode off on a Valliant ecoTec pro28.
only found instructions on how to do it on different models and not this one.
Please see attachment. I have the following buttons: turn off flame, Info, - (minus), and +(plus).
Thanks you.
Hi guys,
Hoping one of you may be able to tell me something I've missed. Bank of 5 boilers, 3 out of 5 showing fault. All were serviced in the summer and were working fine. Until now. In summer boilers had full strip, new electrodes, gaskets, ionisation. All 5 then fired and tested after...
Hi Guys,
I have a combi Vaillant Ecotec pro 28 boiler in my kitchen. I have just added a rad in my garage and have been advised to add a Honeywell frost stat in the garage to be wired up to the boiler. I have also been advised to add a pipe stat to be wired in series to the frost stat but...
I could do with advice in exactly what connection terminals to connect to on the 831 PCB, I'm OK regarding live neutral and earth from the programmers relay which is a bdr 91 but it's the switching part of connecting to the PCB I'm unsure of. ie do I connect to the 24volt after removing the link...
Alright guys, just a quick one. Fitted a vailliant ecotec pro 28 today and upon commissioning the gas rate was slightly lower than 10% of the nominal, which baffled me because ive probably fitted 20 of these boilers and they have all been within range.
All of my other checks where fine so i was...
Alright guys, just a quick one. Fitted a vailliant ecotec pro 28 today and upon commissioning the gas rate was slightly lower than 10% of the nominal, which baffled me because ive probably fitted 20 of these boilers and they have all been within range.
All of my other checks where fine so i...
Dear All
I recently had the above Vaillant stem boiler with megaflo system installed.
I have 2 issues if someone could please kindly help:
1. When I check the control panel no hot water tap symbol appears. Only the radiator symbol even when hot water is switched on. Is this normal or do I...
Hi chaps
Have one of these that builds temp within 30 secs and cuts out in heating or hot water. Vaillant have told her she needs a flush but the rads are brand new and the water looks like drinking water. Don't think a flush will cure it.
Wondered if anyone has come across the same...
Hi everyone, i really need one of your expertise to clear something up!
which is more powerful out the two?
Obviously the electric is 15Kw maximum and the gas is 28Kw but I have read that electric is 100% efficient and gas combi can vary?
i have a three bedroom semi and want to ditch the old...