Hi All
bit lost on an issue with an old back boiler - Open Vented.
Hot water circuit on Gravity (right side) and Central Heating pumped (left side)
Glow-worm Boiler on Ground floor not sending hot water to Cylinder (coil) on 1st floor. Boiler stat cuts out boiler on detecting over-boil...
Hello to all forum members!
Hope that you could share some of your experience and help me solve a little mystery. Perhaps, the title gave you some hints already, but here's what I have found on my bathroom floor after going away for a week:
So I had a look underneath and here's what I could...
Hi
I'm a non-pro about to get UFH installed, and was looking to use Evohome. The issue is Evohome doesn't support floor probes and I was looking to use vinyl flooring.
I'm looking for ideas of how I might build in a secondary fail safe to turn off the UFH pump or otherwise turn off the UFH if...
If you have to run a basin or shower waste perpendicular to the joists I understand that you need to make the hole in the middle of the joists.My question is how big a hole can you make without affecting the structural integrity of the joist and how can you put a fall on the pipe if you have to...
I am not a plumber. My friend had a conservatory built and they extended her central heating but buried the flow and return pipe under the floor. There is only one flow and return pipe feeding 2 radiators so I assume they have split the pipes under the screed to feed both rads.My understanding...
I have to fix a new toilet to my daughter's downstairs toilet.She has just had the floor retiled. The house has piped underfloor heating. I am just a bit concerned about screwing the pan to the floor and whether the pipes will be far enough down not to worry. The previous wc was plugged and...
Hi All.
I'm pretty sure the answer to the above is "no".
I've recently had UFH installed, with a mixture of porcelain (kitchen) and LVT (lounge). I have a mixture of neoStat wall stats but no floor probes. (I was never advised to get such). The UFH in lounge is sitting in Polypipe Boards and...
Evening all,
I've just traced a gas leak to a Myson Marathon 600B. The gas appears to be escaping through the flue. The boiler's a bit before my time but I know the valve was replaced fairly recently. Has anyone any idea how to fix it?
Thanks,
Jock
hi guys, I went to a job today and removed a gas fire and solider a blank on the gas pipe. It was a false floor concrete with battens with finished timber floor. is this classed as a unventilated void? I've looked at my gas book and it only classes apartments to have added ventilation in voids...
Hello, I was hoping that I could get some advice.
I have previously had a large leak somewhere in my central heating system which we could not locate.
As such we have fitted new pipes to the whole system, dropping them from the ceiling to the downstairs.
The old pipes that run under the...
I have seen and worked with radiator back boxes on the ground floor were pipe are dropped in the middle of the rad. and through a back box and looped around to go back to the manifold. However how is it done on the first floor were pipe are coming to the back box from below? Do they go up the...
When installing a gas pipe in the insulation layer below the chipboard flooring. And above the precast beam and block floor. Do most tend to run the gas pipe underneath the insulation resting on the damp course (in coated copper). Or notch out on the top of the insulation and run the pipe in...
ok so I am putting wet underfloor heating in my kitchen, it is 7m x 3m I have dug up the floor and bought 120mm insulation boards ready, my question is how thick must the concrete slab be and how thick does the top screed need to be so I know exactly how far down I need to go?
Also what’s the...
was replumbing my mums new washing machine in for her - lives in a wee old peoples fold and notices the standpipe isn't there just a hole in the floor and the hose sorta pushed into it (now at least I know where the awful smell is coming from) is there any way to put a standpipe in or an adapter...
My system is split into upstairs and downstairs. The upstairs is working fine
but the downstairs is off.
There is no hot water in any of the pipes in the downstairs system, the pump
is on/warm and there are gurgling noises, but all pipes are cold even under the tap (like a radiator tap)
Any...
Hi, I've installed a 2 zone kit that uses an RWC mixing valve, Thermomix with hot in, return to boiler and heat out to Ufh pump and return from floor manifold. From underfloor heating store but basically the same as a jug speedfit Ufh kit.
I thought I had a duff thermostat inside the reliance...
Hi ,
Here again, looking for a little advice, I have my probationary Gas Safe interview in the morning and the inspector is meeting me at a property for a service on a worchester 24 cdi, I went to have a brief look today and saw that the PRV is terminating above the communal alleyway, the...
Hello, im new to the forum and tried to search for a relevant thread, however only error message! So forgive me starting a new thread!
I have a heating system utilising microbore and associated manifolds. I would like to replace one radiator with a single zone underfloor heating system.
Can this...