Hi, does anyone know where I could get one of these drain 'cups' from? Not even sure of the proper name for it. Its in a McDonald's and 2nd time I've had to deal with one of these. First time I just improvised with a multi appliance sink trap but there isn't enough space here. Cheers
Can anyone offer any experienced or expert advice?
I'm being woken most nights especially around 1am and again around 4 - 6am to my floor and bed vibrating. A neighbour has said his water heater/boiler had new valve fitted. He said it's noisy but didn't think it would cause vibration in my...
anyone recommend any? existing floor standing boiler housing space is 870mm high by 580mm wide, in the kitchen.
Worcester high flow was specified by another plumber but I don't think the customer realises that its a combi as he told me he's against getting a combi
I am sizing up a radiator for a newly built room. Now, the bay window is quite large so the space underneath it isn't much.
With this in mind, I understand that the minimum from the floor is 15cm for effective air flow. Question is, how close to the window cill can I go? The window cill isn't...
Hello again!
I'm in the process of installing my bathroom and i'm wondering how is best to connect into the soil pipe. A tee pointing upwards will mean the flexi pan pipe i'm going to use likely would not have fall on it.
Is there a different type of tee piece i could buy that doesn't stick...
Hello.
I should know this, but haven't done it in a screed before.
Have one radiator to connect to an existing system for an extension.
The extension has a concrete floor and the pipes to be laid will be buried in screed.
What's the best method to adopt? I was intending to use copper and...
Evening lads went to quote a boiler change and relocation. then I see the manifold and pump. Have never wired up ufh before then he says we would like to keep our hive system.
Arggggg any ideas lol
cheers
Evening all
Hope everyone is well & have plenty of work.
Been really busy myself for as long as I can remember although I'm not complaining lol
Need everyone's thoughts on a floor standing heat only please
Been to a WB Greenstar 30 CDI regular today & it's f*&ked to be kind lol
Custard not...
Looked at a gutted cloakroom to quote for installing toilet and basin.
At the time was just bare concrete floor. Soil pipe connection from previous toilet was roughly standard height (180 ish from floor).
I thought they were going to tile it.
Now he says they are having underfloor heating...
Hello.
Im installing a new u/floor heating system, nu heat low pro max.
Wondering if anyone can help me or advise in the best position for the pump module.
its a bungalow with 2 separate manifolds, one located under the boiler and one in the hallway cupboard.
the pump module which has the...
Hi, please can some one point me in the right direction.
The property is around 6 years old and I believe all the zones have been working.
The house has a manifold (near the boiler) in the basement, with a secondary manifold on the ground floor with rads upstairs.
The basement manifold feeds...
I have a leak in my bungalow floor. Only bought it last sept but was away in the states for awhile. Looked behind my dishwasher and noticed a ft up the wall is damp and it stretches right around the kitchen. I also noticed my grout lines in my dark tiles aren't dry either. This stretches right...
Can anyone advise if it is feasible to move these pipes below floor level or if they are like this for a reason (picture 1)?
They are hot water pipes. I guess they were put like this for ease rather than anything else?
The second photo is of either a gas or water pipe which I am yet to...
Hi all,
I could really do with some help.
I'd like to know how the floor should be constructed for underfloor heating in my new rear kitchen extension. the builders have laid the concrete floor which is about 20sqm. The outer ground level is quite low, around 55cm.
The new internal concrete...
Good evening all,
To outline the scene, we have fitted a new bathroom( bath & basin) on the 3rd floor of a house and ran the plumbing across the landing to the loft of the two storey extension, where the tanks are located above the hot water cylinder. However obviously the water flow will be...
Am installing a new central heating system (building never had heating before) in my 1960/70's bungalow with a concrete floor and wish to minimize the visible pipe runs to the radiators.
The majority of the pipework is in the loft with drops for each of the rooms in 15mm copper, where...
This is my first post and need help with underfloor heating.
I have just had an extension built with the floor area for this room now circa 24m2. This room is going to run underfloor heating on its own zone. Rest of the house is rads.
System has been installed and just waiting for room...
Hi...can you give me some advice please?. I have lived here for about a year and for the last month only have had severe problems with water pressure ,even the toilet cistern (ALL my water is fed from the mains and not from a tank). In a split second my pressure can go from strong to weak...and...
Walked in on a new install yesterday and there was push fit absolutely everywhere! I've never run it under floors in case of fittings leaking after time, is this the norm now?
Hi all looking for recommendations for floor standing heat only, the present one is 55kw the house is only four bedrooms but it has a manual diverter valve to heat up outdoor swimming pool, I said a modern 35 or 40 kW would probably give out same heat output due to being more efficient but he's...