Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

ideal

  1. M

    URGENT Ideal esprit 30 washers or no washers?

    Hello, firstly I’m not a plumber! But I have just ripped out an ideal esprit 30 boiler from a house completely and safely isolated from any gas or water. I’ve undone all the joints underneath the boiler and found only the cold water inlet to have a washer. Is this correct? Or, have I dropped...
  2. Husk24

    Ideal Logic system s30 boiler making whistling sound

    Hi guys, my boiler seems to be making a whistling sound after a while its on, if I tap it firmly it goes away, is this something to do with trapped air? Any ideas? My boiler is ideal logic s30. Video attached thanks
  3. F

    32 Ideal Vogue Max - reduce pump speed? (noisy expanding pipes)

    Hello all, At the start of the year I had a 32 Ideal Vogue Max fitted and all was well, it's working fine. Problem is, I was getting floors done at the same time so I had a very limited time to notch out / felt between the pipes & joists. I thought I got them all but, I didnt and the noise is...
  4. B

    ideal esprit 2 30 no display UP DATE

    so no display purchased a new one that didn't work either sent it back, so I did some more research and thought what about the pcb the orange one, was in process of getting one when the the other day had the heat on it went off, dead phoned insurance they out engineer pcb was dead one day later...
  5. P

    Ideal Icos 18 Boiler sparked - PCB gone?

    Hi All I'd appreciate advice on what the potential issue could be with this boiler. Its a heat only Ideal Icos 18 fitted to an open vent system It had been switched off during the summer and had occassionally been used to heat water. Turned it one a few days ago and I could smell some...
  6. M

    Ideal standard flusher

    Anyone had any experience with this ideal standard toilet flusher? It presses down and flushes ok with the lid off. But when pushed down with the lid on via the buttons is stiff and and occasionally needs a double press to get going. The buttons move freely and the threaded sections are the...
  7. B

    ideal esprit esprit 2 30 no display

    HI i have a esprit elite 2 30 no display. before I would turn power off then it would come back on after a countdown, no nothing have heat and hot water, have tried another Display but same thing changed the lead as the outer cable was very stiff form the heat and wires had a kink. not sure if...
  8. 5

    Ideal Vogue 26 KW combo high co reading

    HI all, finished fitting the above boiler yesterday. Straight swap, side access flue with only the elbow off the boiler. Gas pressure 21mbars on full chaff. (right by the supply) when doing the co checked, minimum was as expected- 3ppm, .0.0000, and about 7,8% Max on the other hand was 240ppm...
  9. J

    Ideal Logic Weather Compensation Kit

    Hi Anyone know difference between Ideal Logic Combi Weather Compensation Kit(round box) ad new one 216199 model?Need this for my new Ideal Logic + boiler
  10. S

    Ideal Isar HE 35 cutting out

    Hi Guys, Customer has a Ideal Isar HE35 when the boiler fires up for ether hot water or heating, there is knocking noise which seem to he coming from inside the flue manifold. Boiler fires up, knocking noises can be heard from some seconds, after this the boiler cuts out and water squirts out...
  11. J

    Reconfiguring Ideal boiler PCB to correct model and size

    Hello, I am trying to get my Ideal Logic Heat H15 repaired. There have been various faults appearing, with most of them pointing to the PCB. It has been decided that the best option is to try replacing the PCB and using a refurbished part initially for testing. The PCB used on the Heat model is...
  12. J

    ideal logic + low efficient,

    Hi I have 8 months old ideal logic + combi boiler. When I checking "Super Efficiency" reading on the LCD display is 51% only. How to incest efficiency of boiler? Ideal Logic + C24 and Ideal Halo 2 OpenTherm wired thermostat .
  13. J

    Ideal mini bath deck mixer

    Evening I'll go straight to it.... Ideal mini combi and non thermostat bath shower mixer. Run the hot tap on the mixer boiler fires water stays same temp for 5 mins. Move divertor to shower fully hot boiler fires. Then try to add some cold the boiler cuts off. I then fitted a new...
  14. T

    Ideal Logic Combi 24 pinhole leak

    I have a Ideal Logic Combi 24 and the engineer to who comes to service says there is a design fault. It is not a question of if it will fail but when. Apparently the heat exchanger develops a pinhole leak and has to be replaced. Always in the same place. Known about for years. Design has not...
    • Triplemaya
    • Thread
    • combi ideal ideal logic leak logic
    • Replies: 5
    • Forum: Central Heating Forum
  15. I

    Ideal Logic Heat 15 with FD error

    Hi all, Really hoping somone can shed some light on this. I have an Ideal Logic Heat 15 boiler with an FD error. However, the boiler doesn't have a pressure guage or pressure release valve, so I am unable to check the water pressure. I assume this model doesnt work in that way? I have water...
  16. S

    IDEAL icos he30 boiler Opentherm

    Hi all, I have an IDEAL icos he30 boiler. I understand that this is not Opentherm capable, as it is quite old. But I was wondering if there is a way to do this, as I would like to use a Tado or Nest thermostat on it? Any advice would be appreciated. Thanks
  17. K

    Awkward ideal classic boiler replacement - help pls

    Hi, I'ts been a while but its time to call on you guys for some help and payback with a peppering of advice across the forum. I've got your typical ideal classic replacement: side exit flue small high cupboard Etc. I'm looking at regular boiler replacement and would normaly go for a baxi 600...
  18. B

    Ideal Vogue S32 Gen2 occasional ‘NO WATER FLOW FAULT’

    Hi, Following an Anglia Water complete loss of Water Supply in Milton Keynes, I had a call from a Tenant reporting the No Water Flow Fault On the Ideal S32 Gen2. When I arrived at the property I found the pressure in the System Loop was absolute zero. There were boiler manual papers out in the...
  19. A

    Toilet seat ideal standard removed of fixings

    Can someone please advise how I can remove these top fit bolts…..
  20. BoilerNoob

    Ideal Logic Boiler on finance - worth it?

    Our current boiler is 19 years old (and a piece of Rubbish) Had a guy round today from Energy Options Solutions that offered us an Ideal 30kw Logic Boiler on 10 year finance with 10 year warranty. They claimed it would save us 54% minimum on our gas bill per month and we would have a magnetic...

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Featured Content

Back
Top