Hi,
I would be grateful if anyone could give me some advice on a problem i have with a Worcester Greenstar 28i boiler that is fine when i turn the hot tap on but is not firing up to heat the rads. I have pressed the reset button on which the boiler fires up for a few seconds then cuts out. I...
Morning all
had a call-out yesterday to the above, hot water working fine but no heating.
removed the room stat, installed a link but still nothing.
remove the rubber green cap over the D/V that was moving up when hot water called for, then stopped moving for no reason but hot water still...
Hi really need some help have the above boiler, have just come home after few days away and out on heating but it's not working was fine before left. The pump is working making very loud noise but there are no lights at all on the actual boiler as normally is, like the blue front light and green...
Hi,
I have one of these, which is older than the greenstar version. I believe it is called the RSF.
I wanted to buy either of these two, but some posts I've seen elsewhere suggest that they may only work with the newer greenstar, not my RSF:
Any advice appreciated,
thank you,
gbar
Hi,
I have a Worcester Greenstar 24i Junior, just recently we have been having a problem with the hot water.
When you turn the hot water on the boiler kicks in and it starts to warm up but then the water goes cold, also the pressure on the boiler jumps from 1.5 to 2.
After a bit of...
temperature on the dhw does not get as hot as it should, its just a little hotter than luke warm, ch works fine
The diverter is not bypassing
It fires fine on dhw
its only three years old & not in a hard water area so the phe should be okay.
couldnt remove the case because some kitchen...
I hope you can help.
I am not a plumber and have very limited knowledge of central heating.
I have the above boiler and the mechanical programmer has failed (I swapped this about 3 years ago as the previous one also failed).
The boiler provides hot water where needed and also provides...
I hope you can help.
I am not a plumber and have very limited knowledge of central heating.
I have the above boiler and the mechanical programmer has failed (I swapped this about 3 years ago as the previous one also failed).
The boiler provides hot water where needed and also provides...
hi all,
after some advice on the above boiler. did a safety check on it earlier and all readings are good but there is signs of a leak on top of heat exchanger (have got a photo but dont know how to upload it) so i have a burner gasket coming but it looks like water has been pooling at high...
What do you use as in a little connector to be able to get your multimeter to read the voltages. I couldn't get my prongs in the connector on the end of the fan.
Any way, the fault I have is intermittent. The blue light flashes fast but with no lockout. It says in manual volatile fault...
Hi
I accidentally hit the on/off button on my boiler. Now it won't switch back on.
I press the "on" button, it seems to fire up, but then stops the moment I take my finger off the button (or sometimes it cuts out if I keep pressing).
Is there a specific sequence I need to follow to...
Hello, I'm seeking a Gas Safe plumber to come and look at this boiler problem I've got with my 2007-era Worcester 24i Junior combi. As of tonight I can't get hot water from the taps or the radiators to heat up. There is no fault indicator showing, and though the system pressure gauge had fallen...
Hi guys,
looking for a bit of help. I have the above boiler and timer.Come home tonight and its all switched off and timer says 0 days left call eng. Now I have looked on the net and it needs a service.
I have only been here two months and previous tenant said service was done so took his word...
Doing a fan change on one of these today and having real trouble with the gasket on top of the heat exchanger it's too thick to allow me to push the clamping plate down and get the Manifold assembly back in! Is there a knack to this? Anyone had similar problem?
Hi Folks,
I am very sure this question comes up a lot, but I am a little stuck.
I am looking to do my NVQ Level 2 in plumbing and Gas safe. The problem is I can not go via the college route as its far to long 2-3 years ( my nearest colleges suggest) as its part time.
I checked...
Hello. Has anyone come across this...see title
I've checked the two temp sensors got 14 500 ohms on both.
I Checked continuity of harness to fan all ok.
I know there's more i should do but it's not clear in manual.
What voltages to look for on the different wires to fan.
Also what's...
Hello. Im really hammering you with boiler breakdown questions at the moment :thinking:
Worcester Greenstar Junior24i, get 3 mins of hot water then the boiler cuts out. I can hear the heat exchanger fizzing inside so Im fairly certain its overheating. If I leave the hot tap running then it...
Hi guys,
Does anyone know how you go about repressurising a Worcester 28i Junior boiler? I've just moved into a house with one but there's no instruction booklet and I can't see any taps or turnable valves on the bottom? There also doesn't appear to be an internal filling key slot. I'm a bit...
Looking at the 28 CDi Compact and the 28 Junior, the flow rates, heat outputs and dimensions of the Junior and Compact look almost identical to me so what am I missing? I know the Junor is the bottom of the range, but where is the extra money for the Compact going? I know the Junior didnt used...
I misunderstood the purpose of this forum, as I thought it was a general help and information forum rather than a Certified plumbers forum, which is what the answers received imply?
I have absolutely no intention of doing any boiler works (I don't trust myself to put the wheel back on the car...