Hi guys
I fitted a wet room a couple of weeks ago including a new towel rail
The customer is now claiming her boiler is not working properly and it was fine till I did the wetroom, all I did was drain the heating down, fit towel rail and fill it back up, fired it up and it all heated up hot...
Hi Moving my outdoor boiler and boiler house. I'm moving it around to the other side of my house and out a bit into the garden. I've the trench dug out and I'm ready to go this weekend but I'd like some advice before I start to drain and dismantle the boiler.
1. Copper or Speedfit piping and...
I own a property which has two semi detached cottages. The cottages were formally holiday cottages therefore there is one oil boiler serving my house and the two cottages. The cottages are now rented on long term residential lets. Is there any way of metering the amount of fuel each property is...
Hi Folks,
I'm after a plumber to look at my oil boiler (Worcester Heatslave) which has sprung a leaky valve. Not looking to spend too much - have been quoted an £85 call-out charge already, which is a joke. It's not an emergency, but if you work in this area (SY2 to be more specific) and could...
Hi
I've moved into a new house and the boiler is located outside against the wall of the house. The boiler housing its self is made from stainless steel and has a make shift wooden door. Inside there is some old think insulation covered in aluminium foil but it's that old it's falling apart...
Hi everybody I am new to the forum and hope you can help.
I am pretty good mechanically.
I have a problem with my boiler .
on firing up just a few seconds after the burner has ignited there is a single load clunk.
It is not the pipes, but it sounds like it comes from the boiler.
The boiler...
is It possible to connect to a open fire already installed to feed gravity hot water and pumped heating , a conventional oil boiler boiler, its in my own house, never done it before , asked some other plumbers and they said that you can do it with a 3 port valve , there must be a way to do it...
Hi
I have a Grant Euroflame 90/120 Kitchen/utility boiler and I think I’ve worked out how it works.
The boiler is outside in a shed.
There’s a standard 3 wire mains power cord going into it (no other wires).
4 pipes coming out, 2 heats the centre heating, 2 heats the hot water.
There’s 1...
Hello all
A 'plumber' had attached our oil burner after a service to the boiler housing using fire cement... is this acceptable or is this a disaster. If the latter what's the best way to rectify?
im just thinking back and something is telling me that shouldn't have been done... any advice...
Just looking for a bit of a sense check on this one. Situation is that I'm GSR over here but have a property in France that has a fuel oil (French red diesel) boiler and so I get someone over there to service it. I've had some issue with it on it cutting out. I found it to be heavily blocked in...
Hi Guys,
Hoping someone can help me with this,
The problem originally occured when my clien was having their roof redone, and a tile fell ontop of the valve ontop of the storage tank breaking it, and so the oil was no longer getting to the boiler.
Before they realised this was the case they had...
Help .. Running out of options..
I have a client with a Grant vortex utility system 36-46 with riello burner.
There is about a 20metre 10mm oil line under ground from tank to a fire valve (vertical? ) then tigerloop, Then in through a 22mm duct into the property under passage about 2.5mts then...
I have a Worcester Bosch Greenstar Heatslave II oil fired boiler and would like to fit a smart control system. Can anyone recommend the best one to use (e.g. Hive, Nest etc.). Thanks in advance
Hi,
I am looking to move my oil boiler into an enclosure outside and place a wood burning stove where my old boiler was situated.
Can the original stainless flue from the boiler be used for the stove?
Thanks for any advice
Hi, I've just moved into a house that has a woodburner with back boiler supplying hot water for both domestic water and heating, two separate circuits so four pipes into the back of the woodburner. There are 5 radiators and the hot water tank has an immersion heater in addition to the coil. I'd...
Morning guys
has any of you guys worked on a delheat oil boiler with selectos burner and know nozzle size and pump pressure. as went to one and it sounds like a rocket lifting off when fires up .and excess air massively high in th 122 % oil nozzle fitted 1.00 80 eh .can't find anything on...