Hi all,
I'm looking for a part no for the circulation pump in a Vaillant 282. I tried the part no from the manual 16-1068 and gc no 255 300 in my local heat merchants but nothing was showing. I tried phoning the technical helpline but hung up after 20 mins on hold. If anyone had the part no...
Hi all,
I hope you can help me on behalf of a friend who has been without heating in her old stone building for five days now!
Basically, her builder has installed the wrong boiler or something. She needs to get hold of a union for a U16 meter to a 35mm pipe. Does that make sense???
Hi all
Our cistern has decided not to refill around one in three times having previously stuck maybe one in ten.
To make it fill I just have to jog the thin plastic serrated shaft on the left (seepicture) This jogs the whole
mechanism on the left and it immediately fills up.
I'm thinking of...
Hi folks my sink was leaking and I've basically got no idea what was up with it but someone took this part off and told me it was this cause the rubber gaskets/washers are gunned. So anyway I'm wondering what I am looking to buy here to replace this part, I'm not even sure what it's called...
Hi there,
Please could you help identify this part in my central heating system. It has begun to leak slowly from the top of the black plastic. Can you point me in the right direction for a replacement?
Many thanks,
Heya, got an interesting pan to install next week , its split it two I've seen them before however don't know what to use to seal the joint (maybe it comes with a big washer?) link ROTAS DESIGN TWO PIECE WC TOILET PAN - Buy on line
Any ideas?
Does anyone know what this is?
It looks like some sort of PRV to me but I need to be sure before trying to get a replacement :)
My customer is having problems with it leaking all over the place and it's flooding the utility room after a few days of use.
They can't get the boiler replaced this...
Hi all, hoping you can help
DIY (told my the wife) to fit this tap and do not recognise this egg shaped part, and nor do I see where it may fit. I've checked the Franke fitting instructions and they do not seem to reference it. see attached images
Thanks for any support you can provide
Hi guys a mate of mine asked me to see if he could get in with with the company I'm with but he can only do 3 days a week at the moment. Family stuff I think. I told him I'd pass some contact details his way but not to hold his breath as all the engineers are full time.
Long shot I know but...
Morning! Woke up to the same problem of mains water coming out of all the mixer taps when they were turned to hot as well as when they were turned to cold.
Got up and decided to do battle with the shower unit mystery. Saw that the hot/cold control on both showers was set to the hottish...
Hi All,
I have 29 year old Baxi 24kw conventional boiler (No model number sorry) in front of the burners inside the case is what I can best describe as a rectangular piece of insulation\fibre board\rockwool consistency which protects the case from getting hot. This has cracked and fallen into...
Hi, hope someone can help!
So the main pipe which runs down the side of our building taking water from our flat and the flat below's bathroom seems to have come loose from where it meets the ground floor flat. Photo hopefully shows this. All bathroom water is going onto the roof of the garden...
An old lady has a combi
The pressure is very very low, it's an older system & the fill loop is a flexi pipe with like 2 tap heads at either end.
One of the taps won't turn much as all, the other turned but leaks very bad.
I don't know what it's called!! Any thoughts?
I've asked for a fill...
To cut a long story short, I started reading the the WRAS Water Regs book again:
G16.1 d states that a G1/2 size valve (do they mean a 1/2" valve as opposed to, say, a 3/4" valve?) must be 'constructed so that the water shut-off level may be altered [...] without bending the float lever.' So...
Hi All
Ok, just so you can get some sleep - there won't be any more price rushes tonight.
However, there are still all the amazing deals left described in this thread
There are still over 100 promotional offers listed here
Tomorrow morning, the remaining Magnacleanse flushing units will be...
hi all im in my 4th year of plumbing at college, today we started our electrical part of the course then get told after we have passed our exam we are not qualified to touch electrics unless we sit another exam (part p). but my question is if i pay £800 or so to become part p in 4 or 5 days...