The last time this appeared here was in 2014. I intend to fit one maybe 2 to my narrow boat. Is there any more experience of these units post 2014 ?
Many thanks Rob Foster aka centralheatking
British gas done their anal service on the boiler this morning and the guy said I need a power flush which I'd guessed anyway. Quoted me £800. Obviously the British gas have astronomical overheads so how much would it be roughly from Joe Bloggs the plumber?
Hi all can you power flush a central heating system which contains plastic pipe. I have copper just under the Combi boiler then 22mm/15mm plastic pipes then copper to radiator tails many thanks
Hi,
My existing system boiler if fed via a fused connection unit off the ring final circuit, when the boiler is replaced is it a requirement/best practice, that the boiler is fed via a dedicated circuit from the consumer unit to the fused connection unit.
Cheers
Ian
Hi everyone
Got a 35cdi to look at tonight, Customer said they had a power cut and ever since the hw hasn't worked unless ch is on.
Is this likely to be a coincidence and should I be looking at the diaphragm?
Or something else?
Thanks
Hi guys!
I've just purchased a power flush pump system.
And would like some advice on what is the best fluid to use for badly clogged systems that have limescale , and where to buy it from.
Thanks in advance guys!
hi all
I’m having a new en suite fitted and a couple of weeks ago had the Homac 400 macerator fitted for the toilet waste (the plumber took the waste vertically up into loft and across bedroom to stack pipe).
The macerator worked for about a week but one day upon flushing it cut out and tripped...
Hi,
Not sure if in exactly the right forum but someone can point me in the right direction.
Have the boiler mentioned in the title. Had an issue a week ago, boiler showing as if no power reaching the boiler, but checked and power reaching boiler fine. Had previous heating engineer replace...
Not too clued up on domestic control systems, so was wanting a bit of advice,
Potterton EP2001 programmer, CH & HW
MID postion valve
Honeywell T6360 room stat
I've got no power coming into their room stat
The geezer has replaced the stat but didn't make a difference. Hence calling me.
Hot...
hey,
Set up - 3 storey house. Boiler in cellar, sealed system. Ground floor 2 pipe system, the rest of the house is 1 pipe. 2 radiators and 2 towel rails are no longer heating up. Approx 16 radiators in total.
So after fitting a new boiler, running system with cleaner in for a day. Hot...
Hello,
We are in the middle of a power cut at the minute and I'm wondering if running water to make tea, or even flushing the toilet, will put any extra strain on my Ecotec Pro 28 combi boiler?
Many thanks.
Hi folks
Would appreciate any ideas here as I am at wits end.
I have an old BAXI SOLO RS 2 60 boiler. Some weeks ago the heating stopped working and I discovered that the pilot light had gone out. Tried relighting it, which works perfectly until I let go of the gas knob, then the pilot goes...
Got a new boiler in Feb. Was told a power flush was not needed and they added cleaner and next day came for about 30min in attic with hose, said it was clean.
Now I've put heating on again, rads are cold at bottom, so I presume full of slum.
Rang company who fitted boiler, told nothing to do...
Hi all, hope this is in the right place.
So this weekend some delightful charmer broke into my van and made off with all my Bosch 18v battery tools. Grinder, Jigsaw, multitool, brushless combi/impact set, SDS, Radio, light and my Metabo core drill. plus drill bits chisel bits, spare batteries...
Went to this boiler monday for a FL fault the condense pipe was blocked cleared that stripped it down a did a full service all ok, thursday pm phone call boiler has no power , went to have a look internal fuse ok, power in to control box and up to pcb but thats it no lights on control box anyone...
Hi All
I have job to do .
Hotel has 4 cisterns x 300 L water each cistern supplying two rooms with electric power shower 8.5 kW power that need to have min. 8m/min water flow .
Power shower no heating water.
Flow rate is below 7-7.5
No chance for pumps because system is complete mess .
So...
Hi, planning to powerflush a microbore system, it will be a cold flush as need to go through the pump head. Just asking what chemicals people are using, i have been using Adey recently does anyone get any better results using anything else on a cold flush?
Cheers!
Hi there,
I have a norstrom, second hand purchase a while ago and really pleased with it and effective , I am looking for a funded tank to put it in, any ideas where I can pick one up which isn't going to break the bank?
Cheers