Hi
We have just moved into a 3yr old new build house i.e. someone else has lived here for 3yrs and we have just moved in.
We've been in for a few weeks and had no problem, however the toilet in the en-suite is now not flushing. The plunger device on the reverse side of the lid is a big...
Hi Everyone, any recommendations on a toilet macerator that will also have to accept a shower and basin? Looking for a good quality one that will last. Can't use a conventional 110mm soil pipe as the fall is about 1 in 100...
Mystery pipe at the back of the toilet trap
Hi, we have moved into a house with a nice but old toilet, double trap I think, maybe syphonic? It fills up to the top before draining. I was going down the route of it having the wrong syphon fitted but noticed this pipe that has had a stopper put on...
Hi,
I have a Serel Toilet however the seat has broken and i am unable to find the exact replacement for it or replacement toilet seats with the same fittings.
Can anyone please advise on what the model number could be, as can't find it on the seat, have looked inside the toilet and there are...
Hi, I am looking to obtain some toilet damping grease for slow close toilet lid. The grease is of extremely thick sticky consistency and translucent. I have found a source in China, Keermo KM-508 but would like to source something similar in UK. Does anyone know of any grease suitable for...
Hi all, further to my replacement of a cictern syphon, I have a small leak I can not seem to sort out. I have tightened the plastic nut as tight as I dare as I expect it is close to snapping.
What can I do to stop the leak please as my wife is now seriously not impressed with me replacing a damp...
I am looking for suggestions /advice on getting a commercial high pressure toilets that does the job in one flush. Does anyone have any toilets they can recommend?
help/advice required...
two toilets on the ground floor, when the toilet furthest from the soil stack is flushed, the toilet nearest the soil stack (right next to the soil stack) collects waste matter in the toilet bowl. Neither toilets are low flow (modern systems) both ball cock old school...
Hi,
I am installing a new en-suite toilet upstairs in a new location , the soil stack is installed by my builder going downstairs directly and into the ground where the main sewers are. He’s installed the air admittance valve on the floor below , which is slightly below where the toilet is...
Hi, I'm looking for a siamp part, it's the white washer under the cap that flips off.
I've recently changed the inlet valve and realised the water isn't cutting off because this washer has become hard and brittle so it's not moving.
I can't seem to find this part. btw, I don't know what's it's...
I have moved into a property and amongst several other issues, the toilet float valve appears to keep getting stuck and therefore prevented from filling.
I am unsure what type of float valve I have.
Each time I push the top part of the float (pictured on the left) it then starts to fill.
I...
There has been some useful info in other threads on how to start removing an Ideal Standard toilet set. There's no push release on this model, the seat mechanism so has two rusted hex screws attaching the seat that were a pain to get off which then needed some wd40 and heavy force to get the...
Hi I've had a new bathroom plumbed and an en suite in the room next door. All new plumbing to the outside sewer along one wall, plumber had free reign on making it work as there were a couple of obstacles - a chimney breast in the bathroom that the toilets are in front of and an RSJ over a...
Hello, I have a customer that has a 39-year-old Ideal Standard toilet. They would like to replace the toilet seat. But the hinges are fixed on an angle not flat like on a standard toilet. I have attached some pictures.
Has anyone replaced a toilet seat with a set up like this? Or have any...
Built new bathroom on second floor, but the toilet spits back occasionally when flushed.
I think this is a venting issue. Attached is a diagram.
Can anyone see any problems with the configuration?
Thanks
Hi Just removed an old toilet and fitted a new push button cistern one.
I had to re-route the supply water pipe over the waste pipe coming out of the back as i had to use a swan neck one to line up with waste hole in floor,and the water pipe didn't fit past waste pipe.
I cut the supply pipe...
Afternoon all.
New sink and WC being added to attic room. No shower or bath. This "room" will not have a door as such but a curtained doorway (that's what she wants!) into the rest of the attic. The attic has a window that can be opened.
So do regs say I need an extractor fan?
Why try to avoid...
Hi all. I don't do much drainage so after some advice. Is it possible to cut a tee into the top of a long radius bend at the bottom of the soil stack for a downstairs cloakroom?
Sre images attached.
Thanks