Hi All
I am looking to fit a 600mm dishwasher, i will be fitting it under counter in a current 600mm 3 drawer carcass (i presume this is ok once all the drawres/side sliders are removed?)
From left to right i have sink unit (single waste outlet on trap/u bend), space for washing machine (600mm...
Hello,
I would very much appreciate some help/feedback on what I am proposing for my very small ensuite bathroom. While refurbishing it I’m proposing to add a shower. It’s just 1.2m x 1.6m. I have seen similar posts to this on the forum but not quite my situation.
I am proposing to run one...
Hi all,
We are replacing our bathroom “hand wash basin on a table” with a basin on a new wall-hung cabinet with a drawer in it. The problem is, the waste pipe outside diameter is 36mm but the space behind the drawer is only 33mm Behind that gap is a 10mm wide strip of wood (about 30mm high)...
Parents have had a steel beam put into their hallway ceiling to adequately support landing and stairs.
This means that the waste from a sink and shower will need to be reinstated slightly lower into the soil pipe, as the pipes will now run under rather than through the beams (the joists will be...
Hi all, I am hoping someone can advise on this.....bought a 1.5 bowl sink a while ago from B&Q but never got around to fitting it.
Now decided to fit it in my utility room but upon having a look at it the smaller of the two bowls appears to have a rectangular slotted waste exit in the bottom as...
Hello all,
We hope you are well.
We are looking for some drainage advice on a relatively new build property. The drain outside of the property constantly blocks with toilet paper and waste every 5-6 weeks of use.
Following the blockage we unblock by using hot water and essentially poking...
Hello, have a 4m run of 50mm pipe for the shower. The layout of joists, closeness of corner walls etc mean that it would be very helpful to be able to add the basin waste to a swept tee in the shower waste and this could be between 300-800mm from the soil stack . I've read elsewhere very mixed...
Hi
So I am adding an en-suite to a downstairs bedroom and have to install a macerator. I will be using the SaniPlus Up.
I was trying to get a professional macerator fitter but can't get anyone in the time frame (in the next 10 days) so I am trying to fit the waste piping from the macerator...
Hi Everyone,
Can anyone tell me what's the best way to fix this leaky connection union?
Does the connection to the main down pipe need to be horizontal? Looks a bit dodgy to me.
Should I replace with the pipe layout with something like I have sketched with the red or green lines in the...