I have tried to unblock my bathroom sink and managed to undo the u bend pipe and clear any blockage inside.
But there is still a blockage in the pipe leading out of the wall but I can’t see anyway to undo this section. Please advise ASAP. Thank you.
If doing work on a vacant house. When finished do you see it as good practice to turn the water off. I usually do. I'm confident in my work but see this as good practice. Can I ask for others opinions? Thanks
Hi
I had a new boiler installed and wondered if you think this is acceptable workmanship.
Looks like they started to drill a hole at the front and then had to move down.
Thanks for your input.
Hello everyone
Any other plumbers struggling with work during this covid situation?
I went self employed in September was really good up until Christmas then it's been dead as a door nail since lock down came in to force again . I'm not a gas engineer just a general plumber .I've joined...
Hi, I'm in Northamptonshire 36 years old. I have a level 2 in plumbing, I can do the basics like valves, pipe bending, soldering, I'm good on the tools. I just need more experience. Anyone's needing a mate, contact me.
This is how our Builders’s plumber has installed the pipe work under our kitchen sink. It is at the front leaving little room for storage, the dishwasher is connected, it’s an old cabinet that has been moved forward into our new extension until we can afford new units. Is this how it should look...
Hi,
I am new to this, thanks in advance for any support/help!
In the next few weeks I’ll be moving into a house with a VERY old boiler that I will have a pro replace and move at the same time.
I have done small pipe work jobs, e.g. moving a bathroom around. As the new house only has radiators...
Hi,
First post (be gentle!) I joined looking for advice and hope someone can help!
I’m looking to get a wall hung toilet but have a couple of issuers. The wall is breeze block (3 inch thick) then a cavity before the external wall. The cavity is about 4-6 inches in size from what I can tell...
I won't go into the specifics here because it'd be far too long, but in a system I'm building I have two hot supplies - one between 25C and 35C, and one between 45C and 70C. (In short, I have two heat sources that perform differently under different conditions).
I want an output temperature of...
Hi All
I have a question regarding my heating setup, I moved in 5 years ago and since replaced boiler and added 3 nest controls. I have a system boiler with water cylinder and have three nest thermostats, one controls and turns on the boiler for downstairs apart from the conservatory where I...
After advice:
Got a sealed heating system run off an old Potterton Suprema system boiler.
Can only get heating to come on by turning on both heating and hot water. Then once boiler fires turn hot water off and heating kicks in after a few minutes but Heating won’t come on by itself when first...
Hello all, I'm searching for advice on my new system being fitted into a very old stone house in France.
We have purchased a thermflow 300L thermal store with a built-in expansion tank to work with multiple heating inputs (solar, electric and wood burning stove boiler). We are running 7 rads...
Hello, could someone talk to me about how hard is it to get work while doing your nvq level 2? How hard is it to find someone willing to take you on? What's the best way to go about finding work? And if i get taken on how long will i have to work before i earn decent money. Im in my mid 20s...
HI
I’m 32 , doing a level 2 NVQ and gas safe after . Looking to work for a plumber/heating engineer to gain more experience.
All courses already paid for so no outlay to plumber.
Thanks,
Henry
Have completed a diploma in plumbing studies and am currently looking for work to allow me to continue my studies in nvq level 2 within the sussex area thanks
With my first grandchild due in October and a 2.5 hour journey each way to visit my son his partner and new granchild I need to upgrade my ageing Honda CRV I think it will be another one but maybe a automatic this time , what do you guys drive and use as a family car and recommend for long...
Hi everyone, just a question for my own knowledge and understanding of how water works in my flat and making sure everything complies with water regulation in the UK. , The flat is circa 1960s used to have a hot water cylinder and cold water tank in the cupboard but since late 90s or early 2000...
I am new gas safe and met hard situation when I did gas safety check on large property with 3 acre site. The property is old and large size, installed two 30KW heat only gas boiler to supply CH and DHW, range cooker and gas hob. I was be told the meter is installed at the entrance of the...
Small family owned growing company looking for honest, reliable plumber in the Ft Lauderdale area. Anyone looking to move to South Florida or is located in Ft Lauderdale area send me a message.