Alternative to trac pipe or trac pipe

[ShaunCorbs]

Monuments tube cutters

You can use a hacksaw just always cut in the grove

Don’t cut the plastic cover till you cut to length then it’s one grove back I think

300mm grips or knipex pliers grips

It’s easy and fast

https://www.gastite.co.uk/pdf/installation_guide.pdf

 

[mutley racers]

Monuments tube cutters

You can use a hacksaw just always cut in the grove

Don’t cut the plastic cover till you cut to length then it’s one grove back I think

300mm grips or knipex pliers grips

It’s easy and fast

https://www.gastite.co.uk/pdf/installation_guide.pdf

Are the monuments for stainless then?

Thanks for the link.

 

[mutley racers]

Monuments tube cutters

You can use a hacksaw just always cut in the grove

Don’t cut the plastic cover till you cut to length then it’s one grove back I think

300mm grips or knipex pliers grips

It’s easy and fast

https://www.gastite.co.uk/pdf/installation_guide.pdf

You don't mean the cutters that cost £80?

 

[ShaunCorbs]

Are the monuments for stainless then?

Thanks for the link.

copper tube but change the wheel for a stainless one cuts it fine then

Monument Pipe Cutter 4-28mm

eg Monument 284I Spare Wheel for Stainless Steel Tube Cutters 265B 266E 1 2A & TC3 5015375002844 | eBay

 

[ShaunCorbs]

or if your doing alot

Cutters | Gastite | CSST | Pipestock

 

[mutley racers]

or if your doing alot

Cutters | Gastite | CSST | Pipestock

Blimey!!!

 

[mutley racers]

copper tube but change the wheel for a stainless one cuts it fine then

Monument Pipe Cutter 4-28mm

eg Monument 284I Spare Wheel for Stainless Steel Tube Cutters 265B 266E 1 2A & TC3 5015375002844 | eBay

Thanks for the link. The 25dn gas tite is around 35mm. Good idea with the wheel though

 

[ShaunCorbs]

Just fitted some today no problem 6m of 32mm

Cut to length
Two indents back slice with knife sheath
Put nut and split collars on
Insert into fitting
Tighten job done

 

[mutley racers]

Nice. I did get there in the end

 

[ShaunCorbs]

Nice. I did get there in the end

What was wrong / what did you do in the end

 

[mutley racers]

What was wrong / what did you do in the end

I bought a big knipex and pipe cutter and gave it a nice clean cut on the end a d tightened it up with some shear strength and hey presto.

 

[ShaunCorbs]

300mm ?

 

[mutley racers]

300mm ?

Yes indeedy. Thank you for the recommendation

 

[ShaunCorbs]

Your more than welcome