Gerebit Flush Valve too short, any ideas how how to make the button sit higher?

[Tim Barnes]

I've bought a replacement flush valve for (Geberit 282.350.KD.1 Flush Valve) as the last one fell to pieces, it works perfectly but the top down button is about 2 inches too short to sit in the hole on the cistern lid.

Is there an easy way to get it to sit higher?

You can reach it if you have long enough fingers but it's only a short term solution! Any help appreciated, cheers, Tim

 

[rpm]

2 inches is a lot, was it a like for like replacement?

 

[Harvest Fields]

2 inches is a lot, was it a like for like replacement?

Said the actress to the bishop😉😉

 

[Harvest Fields]

Do the buttons raise?

 

[Welder]

Mr Barnes. Did you work in Horsham?

 

[snowhead]

Have you adjusted the valve up to it's upper limit?

 

[Harvest Fields]

Have you adjusted the valve up to it's upper limit?

That’s what I was saying.

 

[snowhead]

Do the buttons raise?
That’s what I was saying.

Thought you were still talking about the Bishop...

 

[Tim Barnes]

2 inches is a lot, was it a like for like replacement?

They stopped making the exact same part in 2007 but the Gerebit support line person said this would work fine...

 

[Harvest Fields]

They stopped making the exact same part in 2007 but the Gerebit support line person said this would work fine...

Then it should raise to the same level as the old one.

 

[Tim Barnes]

Have you adjusted the valve up to it's upper limit?

nope, didn't realise you could but sorted - cheers!

 

[Welder]

nope, didn't realise you could but sorted - cheers!

🙄 A valuable lesson learned 😉