Ideal icos he

[chelsea]

LF code showing up,been looking on the site but no definitive answer

cleaned condense trap and checked to make all clear and is fine, and spark electrode had to be re-positioned as slighty bent so was not sparking, it ran for 10-15 mins then LF showed up

I was thinking maybe flame sensing probe duff

Any advice would be much appreciated

​

 

[BLOD]

I'd check the flame detection electrode too & the ignition one
If it's not sparking on start up check for 240v across blue & brown on spark generator

 

[buckley plumb]

check the leads seen a few melt to the heat exchanger

 

[Billy Bob Bob]

check you have not trapped the lead when you dropped the pcb down

 

[diamondgas]

If you have a FGA it'll let you know if the issue is flame or flame sensing, that is if the flame is burning constantly for the time you mentioned! It the flue vertical?

 

[arran197]

Check all the earth points, including the burner earth pins on the front and rear of the burner.

 

[zeebeedee]

Borrow gas mans axe or rip it off the wall with your teeth and stick it in the canal!

 

[dancinplumba]

please, please don't stick it in the canal...recycle it !! the possibilities are endless, could become parts in another ideal boiler 🙂