ideal vogue 32 analyser readings

[mutley racers]

I have just installed this boiler. Nice fancy user interface. In service mode in max rate I am getting

O2 4.2
co2 9.5
Co ppm 129
Ratio .0013

Ratio and co is quite high. Usually when commissioning a new boiler I get a ratio of around .0007 and about 70 ppm co.

Pipe sizing is all fine and that. Flue is all good too

 

[Rickster123]

What does it say in the m.i mate?

 

[bewsh]

Is the CO2 % correct?

 

[mutley racers]

Doesn't give any combustion readings in their MI'S when commissioning. Only gas rate and inlet pressure. Does on servicing though. Just the norm, if it's less than .004 great

 

[kris]

Ideals MI, s are very vague when it comes to commissioning. That's only downside to there boilers. They say ad long as ratio below 0.004 and CO below 200.

 

[Aquazone]

If inlet, WP and gas rate is spot on, and there are no specifics on CO2, as long as your below 0.004 and 200ppm, then your ok.

I think the Logics run at about 0.0011-0.0014 as well, if I remember right.

 

[Ermintrude]

It's all gravy now get and play with graphs

 

[Whyme]

The co could be burning off the newness inside. co2/o2 slightly gas rich but if ratio's below mi sorted.

 

[kris]

All the ideals I've fitted although are great boilers they've ALL been set to burn at the same levels.. TBH they could be set a bit cleaner but we abide by Mi's and they're left because they're within limits.

 

[mutley racers]

It's all gravy now get and play with graphs

It is fun to play with a. Very smart

 

[smtplumbing]

HAppened to me got ideal out it was the gas valve

 

[Scott_D]

I fitted a 26 combi today. It gave a 0.0013 ratio in max mode.
Its within manufacturers spec and was working very well