Does anybody know of anything that would work as above. Ideally inexpensive and readily available. I need to move a brass stopcock on mdpe from the center of a kitchen unit back to the wall. I can cut the 50mm duct back and break a small trench in the screed and then go from mdpe to copper with a Phil Mac or johnguest fitting but the fitting will end up in the screed and so I would like to keep it a: protected and b: afford better access than simply screeding over. Kitchen is moving in to an extension and existing kitchen knocked through to make bigger lounge.
I know polyplumb have them for underfloor manifolds and such but I'm not sure they will fit larger fittings like the philmac and they always seem pricey for essentially a piece of Tupperware. Any ideas or secret sources out there on't tinterweb?
I know polyplumb have them for underfloor manifolds and such but I'm not sure they will fit larger fittings like the philmac and they always seem pricey for essentially a piece of Tupperware. Any ideas or secret sources out there on't tinterweb?
