OK I could tell the whole story but this is where I am now . The boiler will work for a day or two and then lock out with ignition fault. Reset and it may go for another couple of days. Heating engineer could find no fault & said wait until it fails altogether. Thought I might as well change the PCB, got a refurbished one and it locked out immediately but with circulation fault! I surmised I had been sent a dodgy board, sent it back for a refund, bought a brand new one and this does the same, , circulation fault!! Arghh. Put back the old one and back to 2 days running then ignition fault. So.... must I presume the old PCB is knackered and is displaying the fault incorrectly & I really do have a circulation problem??
- Thread starter martinthefirst
- Start date
Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
- May 23, 2015
- 35,139
- 1
- 14,996
- 113
- Member Type
- Heating Engineer (Has GSR)
About 10 years, It is on setting 1 of 3 I could turn it to 2 and see what happens?
- May 23, 2015
- 35,139
- 1
- 14,996
- 113
- Member Type
- Heating Engineer (Has GSR)
OK, will do, I turned it down a few years ago as I was having to bleed the radiators and I think it was pulling in air, and it solved that problem. Maybe the pump is getting tired.
OK, no improvement, any Suprima HE experts Croydon/Bromley area out there who would like the job?
Official Sponsors of Plumbers Talk
Similar plumbing topics
We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.
