Unvented direct hot water cylinder

[JohnJeff]

I have got an Albion 210 Ltr unvented hot water cylinder and the electrician seems confused about wiring it.
There are two 3Kw Elements, one nearer the top. The House has a split Tarif meter so there is cheap night time electricity. Any advice welcome

 

[Millsy 82]

Usually the lower goes on the cheaper electricty as it would heat a whole tank overnight the other would be used as a boost

 

[SimonG]

Bottom element to cheap rate, top element to normal as a boost if you use up all your hot water. imho.

 

[SimonG]

Usually the lower goes on the cheaper electricty as it would heat a whole tank overnight the other would be used as a boost

Snap 🙂

 

[northcarr]

Tell your sparky to give Albion a call they will advise him the best wiring layout,ps the 2 port diverter valve that came with the cylinder needs to be wired back to the overheat stat hope this helps.

 

[SimonG]

Tell your sparky to give Albion a call they will advise him the best wiring layout,ps the 2 port diverter valve that came with the cylinder needs to be wired back to the overheat stat hope this helps.

210 litre with two immersions, twin supplied board, my monies on a direct cylinder. 🙂


Especially as its in the title 🙂 🙂 🙂 🙂

 

[JohnJeff]

Thanks. But there are not two seperate electricity supplies, one consumer unit and two metres. The meter just switches to night time counter at night so the actual electricity supply is always the same.

 

[SimonG]

Thanks. But there are not two seperate electricity supplies, one consumer unit and two metres. The meter just switches to night time counter at night so the actual electricity supply is always the same.

More of an ewlectricians question then. Have a look at the electrical forum, link at top of the page. Good luck.

 

[JohnJeff]

Thanks

 

[tamz]

It needs controlled by an Economy 7 timer like this one
[DLMURL]http://www.horstmann.co.uk/downloads/ElectronicDocuments/Electric-Water-Heating/E7Q-UserGuide.PDF[/DLMURL]

 

[PlumbBobBob]

sounds like you will have to have some sort of timer to switch between immersions an electrician should be able to sort you out as has already been said.

 

[PlumbBobBob]

It needs controlled by an Economy 7 timer like this one
[DLMURL]http://www.horstmann.co.uk/downloads/ElectronicDocuments/Electric-Water-Heating/E7Q-UserGuide.PDF[/DLMURL]

beat me to it lol

 

[tamz]

A better link showing how it is wired
[DLMURL]http://www.horstmann.co.uk/downloads/ElectronicDocuments/Electric-Water-Heating/E7Q-InstallationInstructions.pdf[/DLMURL]

 

[tamz]

beat me to it lol

:lol:

 

[zzzjim]

Basically its a Change over switch that chooses which heater gets the power depending on the time ,

and hopefully only does the top-up boost when you press the button .

Economy 10 has some day time ! Just to confuse !