Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Hi I have a worchester heat slave 18/25 and continually needs bleeding in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
1
Hi I have a worchester heat slave 18/25 and continually needs bleeding of the Kero, runs all day when bled. when it cuts out on the stat it wont start again without bleeding
 
Is the tank higher than the oil pump?, what is the oil level?
Is it a one pipe system with the blanking bypass screw installed/ or a 2 pipe or a tiger loop?.
Has the flexible hose been replaced fairly recently?.
 

Reply to Hi I have a worchester heat slave 18/25 and continually needs bleeding in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no...
Replies
6
Views
249
Hi, Later this year I am going away for a 2 week holiday and as the weather will be warm there is no need for the heating to be on and arguably...
Replies
1
Views
163
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
207
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
384
Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath...
Replies
2
Views
214
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock