Hi everyone. I just removed a shower tray and this is what I found underneath, does it look like a conventional way to create a shower tray support to you? the tray was a 900x900 Merlyn Mstone ABS Capped acrylic. thanks
Discuss how to create a base for a shower tray. Does this look normal? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Messages
- 6,157
Errr in a word no looks a right state to be honest hope it's coming out, I like the Merlyn trays so much easier to buy their riser kit than stick a forest under it . Kop
thanks. Also the waste was glued underneath the tray??
- Messages
- 34,368
- Solutions
- 2
nope sorry to say that wasnt a very good way to fit a tray normally 3 or 4x 2 and a piece of 18mm ply level and supporting the tray fully
Reply to how to create a base for a shower tray. Does this look normal? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi All
I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could...
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Hi,
I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new...
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Hi everyone,
Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...