PriestyUK
Gas Engineer
- Messages
- 220
Is supply on a new meter? Get water board to remove the meter and fit a temp outlet straight off where the meter screws into. Do your check there with the water board present. That way you can rule out if its before or after the meter thats causing the problem. Just had the water board do the same but because of poor flow rate and it was down to their new taping not cutting fully into the main. And they checked this by removing the meter and screwing in a hydrant outside tap looking device. Think this is your best way to start. If fine I think you could have some gravity circulation taking place and may have a hot pipe close to main. Eliminate all heat sources and let go cold and see if you still have a problem.
Will be cool to find out what the outcome is - #Subscribed
Good luck
Will be cool to find out what the outcome is - #Subscribed
Good luck