Search the forum,

Discuss shower in winter on combi boiler - is it ok to restrict water flow & get hotter water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

Mrs Tara Plumbi

As per title can anyone tell me the answer?

Mr TP (otherwise known as he who is never here) has told me that it is not good to restrict water flow on combis in this way.

But i am not clear on this - is it about how much water is restricted or about the length of time?

The combisave restricts water flow - for a very short time - so perhaps that doesn't matter.

I skimmed through this very complicated document a long time ago and i think it said all depending on the boiler it would be a very bad idea to restrict below 3 LPM - i guess I would still have a shower greater than 3 lpm.

: http://www.elementalsolutions.co.uk/downloads/combis and low flows.pdf "Combination Boilers and Low Flow Fittings." © Nick Grant; Elemental Solutions 2007.

(must add - because some of you guys are so sensitive - I meant I find this document difficult, I know many of you are trained in this and deal with this sort of info every day...)

But i have often wondered if you can imagine a woman like me standing naked in the shower, covered in soap

- in the winter do I still have to turn the shower on full and shower in tepid water?

To be fair - as i often tell people i have a Remeha i should tell you that this is not a problem but i have had this experience from other combis in the pat and you all know it is a common problem.
 
Last edited by a moderator:
Re: shower in winter on combi boiler - is it ok to restrict water flow & get hotter w

I now have a picture of naked soapy Mrs TP.........Thanks for that. :cheesy:

To my mind why reduce the flow to the boiler?
If you reduce the flow too much you wont make the flow switch and the boiler wouldn't fire.
The boilers are self modulating meaning the burner is linked to the flow temperature.

I would of thought it would have been better to just not turn the taps on as much?

You should only ever have a problem if you have a very long pipe run and its in the depths of winter (so incoming mains is really cold).
Try lagging all of the hot pipework.
 
Re: shower in winter on combi boiler - is it ok to restrict water flow & get hotter w

Hi Tara, nice thought about a seeing a naked woman in the shower covered in soap, also good to see you have an excellent boiler.

From what i would say is the slower the water is passing through the heat exchanger or the bigger the heat exchanger the hotter the water will be, all boilers would have a minimum flow rate to prevent damage to the secondary heat exchanger, or to prevent the main heat exchanger over heating and turning off.........if you compare it to the fault you would get when the secondary becomes partially blocked it would have the same effect boiler cycling on/off.

I always recommend the the largest heat output combi's for exactly that reason.

Chances are that be restricting the flow to much the flow sensor may not activate anyway.

Bob
 
Status
Not open for further replies.

Reply to shower in winter on combi boiler - is it ok to restrict water flow & get hotter water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
219
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
261
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
365
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
284
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
210
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock