I
Inerz
Thanks for taking the time to read, and sorry if posted in wrong section wasn't sure if it was generic as includes both shower and heating system.
I've just purchased a property built in late 2010, 3 story's and the previous owner was a British Gas engineer so therefore had an unvented system installed professionally ( won't find a better system on the whole estate apparently) however the only problem is that the en suite shower, located on the same floor as the cylinder approx 5 metres away, is little more than a trickle, very difficult to wash under, was wondering what the problem could be as its a real nuisance, the stopcock under sink is fully open, what steps should I take? Should I measure the litres of water from each tap on each floor to check flow rate is there? Or is there something else a miss. I've attached 3 photos of the system. Thanks for any help.
I've just purchased a property built in late 2010, 3 story's and the previous owner was a British Gas engineer so therefore had an unvented system installed professionally ( won't find a better system on the whole estate apparently) however the only problem is that the en suite shower, located on the same floor as the cylinder approx 5 metres away, is little more than a trickle, very difficult to wash under, was wondering what the problem could be as its a real nuisance, the stopcock under sink is fully open, what steps should I take? Should I measure the litres of water from each tap on each floor to check flow rate is there? Or is there something else a miss. I've attached 3 photos of the system. Thanks for any help.
