G
Georgie
Hi All,
I've found that when soldering pipes with pre-soldered connectors they always leak a little bit. My technique is to put some flux on the pipe, push the connector on and then blowtorch one side until the solder drops out.
Should I do anything else? Maybe my blowtorch is to hot/cold? I also wondered if i should try and move the blowtorch around the pipe to evenly distribute the heat.
any suggestions welcome
I've found that when soldering pipes with pre-soldered connectors they always leak a little bit. My technique is to put some flux on the pipe, push the connector on and then blowtorch one side until the solder drops out.
Should I do anything else? Maybe my blowtorch is to hot/cold? I also wondered if i should try and move the blowtorch around the pipe to evenly distribute the heat.
any suggestions welcome