Search the forum,

Toilet- Sealed unit. Tightening

Post new thread

Discuss Toilet- Sealed unit. Tightening in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

James Welsh

Hi all

We have a toilet which is a sealed cistern/bowl unit and the seat is now really loose.

I can't see how to gain access to either remove the seat or get to any bolts to tighten?

Any ideas?

Thanks

James

image.jpg


image.jpg


image.jpg


image.jpg


image.jpg
 
If you need new fixings they can be found on fleabay.
 
Status
Not open for further replies.

Reply to Toilet- Sealed unit. Tightening in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
322
Bp89
B
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
210
dreikher
dreikher
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
217
SimonG
SimonG
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
539
Chuck
C
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
7
Views
260
Raff
R
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Standards BS5389
Tile Cutters
UK Tiling Forums
Tiling News
Contractor Advice Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock