Worcester Greenstar 24i Jnr

[jaydebruyne]

Never come across this before..

Boiler in demand for heating, sounds like running water from the bottom of the flue where it meets the condense trap, also a gurgling sound from the terminal (went to check for blockages). Condense run blocked? Boiler keeps locking out.

Also, fan sounds like it's taking off at times. Checked fan and no apparent faults. Spoke to Worcester who said could be the bearing membrane.

Anyone come across these and can shed some light?

Cheers

 

[Billy Bob Bob]

condensate trap probably blocked,have you cleaned it?

 

[ShaunCorbs]

Had a few condense trap not cleaned out (also see water coming out the flue terminal if horizontal)

 

[jaydebruyne]

condensate trap probably blocked,have you cleaned it?

No.. literally just went to have a look, gonna quote to do the works as didn't get there til 7:30 this evening.. gonna do it all when I replace the membrane for the fan. Also gonna replace his flue as it's in a bit of a state from builders moving the boiler location when doing an extension

 

[jaydebruyne]

Had a few condense trap not cleaned out (also see water coming out the flue terminal if horizontal)

Yeah this was horizontal but didn't see any water coming out, exhaust was clear

 

[Billy Bob Bob]

Had a few condense trap not cleaned out (also see water coming out the flue terminal if horizontal)

And me,also seen the 21.5 block solid if its connected to a sink,doubt its a bearing plate as worcester have advised,these normally vibrate or a smell of gas through the fan when they fail

 

[jaydebruyne]

So could a blocked condense cause issues with noise from the fan? Since it's linked to the flue...

 

[Billy Bob Bob]

Yeah this was horizontal but didn't see any water coming out, exhaust was clear

Depending on the trap fitted they block very easily,would remove it too check,and check the condensate run

 

[jaydebruyne]

And me,also seen the 21.5 block solid if its connected to a sink,doubt its a bearing plate as worcester have advised,these normally vibrate or a smell of gas through the fan when they fail

I smelt gas.. had to put a sniffer to it at one point but it went

 

[Billy Bob Bob]

So could a blocked condense cause issues with noise from the fan? Since it's linked to the flue...

Yes,it causes the boiler to gurgle

 

[Billy Bob Bob]

I smelt gas.. had to put a sniffer to it at one point but it went

check trap and run first,if there is a bearing plate issue you will smell gas through the fan motor

 

[jaydebruyne]

check trap and run first,if there is a bearing plate issue you will smell gas through the fan motor

Ok cool.. well I'll order it just in case.. cheers guys 🙂

 

[Billy Bob Bob]

Ok cool.. well I'll order it just in case.. cheers guys 🙂

There not expensive,about a tenner,got 2 to do this week

 

[ShaunCorbs]

And me,also seen the 21.5 block solid if its connected to a sink,doubt its a bearing plate as worcester have advised,these normally vibrate or a smell of gas through the fan when they fail

Had one just under half full of condense sounded like a washing machine when fan was running

 

[ShaunCorbs]

Yeah this was horizontal but didn't see any water coming out, exhaust was clear

Would say it hasn't been serviced for 6-9 years

 

[jaydebruyne]

Had one just under half full of condense sounded like a washing machine when fan was running

Pretty much what this sounded like!

 

[jaydebruyne]

There not expensive,about a tenner,got 2 to do this week

So the bearing plate & membrane sit inside the fan don't they? So take the fan out and take apart the fan?

 

[ShaunCorbs]

So the bearing plate & membrane sit inside the fan don't they? So take the fan out and take apart the fan?

You half way there to do a full service if there's money for the extras jay (new burner seals and electrodes etc)

 

[jaydebruyne]

You half way there to do a full service if there's money for the extras jay (new burner seals and electrodes etc)

Might just sell it that way Shaun.. Makes more sense. New flue, boiler service etc - sounds tidier!! Cheers 🙂

So the bearing plate/membrane is inside the fan, right?

 

[ShaunCorbs]

Might just sell it that way Shaun.. Makes more sense. New flue, boiler service etc - sounds tidier!! Cheers 🙂

So the bearing plate/membrane is inside the fan, right?

Without looking it up don't have a clue sorry , why new flue?