I wonder if anyone is able to help with advice on this. We have fitted a new toilet and 6 litre cistern .. it flushes .. but not as efficiently as it should in my view. It usually needs at least 2 flushes to even shift just toilet paper. It hasn’t been used for anything other than that.
It’s a...
Hello,
Recently I received an unusually large water bill which led me to the discovery of leaking flush valves. I have two toilets and it turned out in both the valve seals were bubbling so I set out to replace them. For now I just flipped them over as the other side was smooth on both.
The...
I have a Geberit concealed cistern . This has a dual pneumatic flush, and has worked without any problems for a few years now. The short flush continues to work normally but the longer (6 litre) flush no longer flushes fully which results in solid waste not being flushed. I have checked the...
Hi there,
The issue that I am having is I am building a new house and the plumbers are absolutely hopeless. Being an industrial plumber and spending 8 months on new houses during my apprenticeship. I have a more brighter idea than these fella's. From issues during rough-in-stage pipe being...
Ive looked at the tech specs and it seems that the REMS has a lower flow rate but higher pressure at 5.5 bar. the Kamco has a higher flow rate so i understand that will be best for flushing a dirty system, however its maximum pressure of flow is under 2 bar. I wish to use a mashine for...
Hi everyone,
The flush button on my toilet has stopped working. I have been quoted £95 to supply and fit a new flush valve and £75 to supply and fit a new ball valve. Please could someone kindly advise if this is a reasonable price?
Thank you.
Hi all,
I had my new boiler and 13 radiators installed in July last year, but since installed all the radiators always top half hot and bottom half cold or warm. I know that if radiators top half hot bottom half cold/warm, it indicates there's sludge in the system. But as the radiators were all...
Hi there, our flush valve is still raising but refusing to drop back down. Been to all the plumbers merchants but none have anything that will click into the existing cradle. Its going to be far too difficult to remove the cistern and replace the cradle.
Any advice pleas on where I might be...
I've just had a Bathrooms tonlove sandro rimless toilet installed as part of a bathroom refurb. Unfortunately the flush doesn't reach the front of the bowl and looks like most of the flush is being channelled down the back 5 holes at the back of the pan.
It's a btw toilet fed from a concealed...
Hello
Can anyone tell me if it is possible to buy a toilet which has cistern flush capacity (not sure if I have phrased that correctly) of more than 6LTRs?
We previously had a Royal Doulton toilet which was accidentally thrown away when had the bathroom changed. New toilet is one of these...
Hi everyone,
I live on a top floor flat and would like to know when I run the kitchen cold tap should I run it for a few seconds before drinking it or will it not make a difference?
Does water sit in pipes when not used and should water in a kettle be replaced if it has been sitting for more...
Hi, I have a dual flush toilet that's leaking water from the cistern to the bowl. I've taken the flush system out cleaned the washer of gunk, cleaned the bottom of the tank and it's still leaking-in fact it was leaking more at 1st! I rotated the unit a little and it slowed down; I can't rotate...
Any recommendations for a push-button toilet dual flush valve, please (and must have a cable over 310mm)? Tried a Fluidmaster model but plumber says it won't fit the 2" flush pipe. Thanks.
Hi, new to the group and need advice with my Vitra ts823. The toilet stopped flushing and there is water constantly trickling inside it. I've removed the lid but not sure which part is knackered. I've tried pulling /pushing any bits that look like they should move but the trickle doesn't get...
The syphon activation cable on my old Bathstore A2432 dual flush valve has broken and I don't want to have to remove the whole cistern to replace the the complete unit. Does anyone know of a replacement valve the syphon part of which I can use to slot into the existing cradle, please? I hope...
Hi all.
I need to improvise a flush pipe some how. Anyone managed to do this with waste pipe at all. Basically the cistern is on the back of a 2 inch stud wall of where the toilet will go. The pipe cannot go straight down due to a washing machine needing to fit into the space below the...
Hi Guys,
I have a toilet where when you flush, the water from the cistern leaks out from a section of the cistern at the bottom where the seat area begins at the top just before the bowl.
Was wondering how this could be happening or how it could be fixed?