Hi all,
I was just posting on here to see if anyone has had anything similar or can point me in right direction…
I have a Geberit concealed tank within the wall so a floating toilet and over recent weeks have found that the brick work just outside of the toilet area (downstairs toilet) has...
Hi can someone please advise, I have a small leak on the pipe leading to the pressure guage on a glowworm compact 100e boiler, can these be replaced, can the pipe be cut to remove the leak, or do I need to replace the whole guage.
Thanks for any advice
Pete
Hi, wondering if anyone can help. I have a leak coming from my oil boiler only when the boiler is fired up. It's down the bottom with beside a bolt and what looks to be a bleed nipple
My wife got oil delivered and they bled the boiler. Is there anyway a leak could happen from someone...
Initially this valve was leaking, so it was tightened up, but there was some micro weeping? Left tissue paper around the bottom overnight but then in the morning wiped tissue around it and there were signs of water.
Now it was the cold pipe and could it be condensation as the last couple of...
Hi - Novice here. Under our kitchen sink, the waste pipes are grey, with a green moving 'lip' and then a cover peice that in theory tightens over the connection. The two downward pipes from the sinks go into a cross pipe (along with the washing machine outflow) which then leads outside. However...
The spindle on the LSV is leaking and I don’t fancy changing the valve for fear of starting with one leak and ending up with three! So, I am going to try the trick with Loctite 55 and wrap it around the spindle and put the nut back.
My question is, should I also use a dab of hawk white or...
Hi everyone. Looking for some regarding a leak in my vanity unit.
Plumber installed vanity unit and cut pipes and added connectors to them. I have checked yesterday and the cold water one seems to be leaking. Is there any putty or sealant that should be applied to these small plastic screw...
I have a 15mm T-junction on a cold water pipe that has a small drip from one of the joints. It is in quite an inaccessible place (in between a ceiling and the floor above). I can get access from below but there is not much clearance from the floor above. To get access from above I would need to...
Hi I replaced my hot and cold tap tonight cause the cold tap couldn’t turn the water of tap was just spinning. Fitted fine with no leaks. Now I have a leak coming from the middle bit where the chrome threaded ring is. Do I need to tighten the chrome threaded bit up in the middle to stop the leak...
I have a dripping sink trap which it seems needs a replacement washer. Sink trap kits I've found contain the right type of washer - a flat O-ring, but the sizes tend to be 32mm or 40mm. The 32mm are a bit small and the 40mm way too big. Any idea what I should be looking for?
Hi all,
First time renovator and registered plumber. I'm replacing my old full turn taps with quarter turn taps that have ceramic disc spindles, but the new taps seem to randomly gush hot water while the handle is turned off after they have been used, any ideas on what could be going wrong? We...
How do I get access to the flow cartridge in the Hansgrohe Bar Shower. It has the control with the 50% mark on the flow side. See attached photo - the end piece pops off but hard to see whether the small button should also come off to slide off the cover and reveal the cartridge
Hi All
Noticed the floor around shower had a pool of water, looked like shower leaking from below, presumed it was trap but all good, could not see where water was coming from?
I turned on the showed head and viewed underneath base and the ONLY time i had a leak was when the water jet was...
Hi,
I recently detected some leaks from my bathroom. Part of the issue was water escaping from the bath screen.
A plumber refitted and sealed the bath and screen. Unfortunately, the water is still escaping near the base of the hinge of the shower screen.
I have attached a picture of the base...
Hello All,
Yes, another 'leaking cyclinder' question...I'd be grateful for your advice.
Vented 90x45 cyclinder in loft. Connection in question is not flow or return but an additional 5th connection that seems part of a separate system with dedicated hot water tank and shower pump. Can't get...
Hi all, I need to replace this valve as it's dripping even when turned off so presume its old and worn out. How do I isolate the water supply to it? When I open it slightly water comes out a lot so if I take the valve off completely to replace it do I just need to quickly get the new one on and...
I have a shower mixer tap on bath, flow on left temperature right but leaking from temperature control on right side, found a replacement but the flow and temperature reversed, is that ok
Hi, we have a rectangle three walled tiled shower with acrylic base that is leaking in both corners - was only built approx two years ago so really not wanting to replace. So far have had the original plumber and tiler look at it but couldn’t find the source of the leak. Silicone where the tray...
An anyone help fix
issue started with constantly dripping in bowl. Changed the value on the fill part
now noticed this part is constantly dripping and I believe causing further dripping in to toilet. So much water comes in to the cizsten aswell.
can anyone offer any help
Hi
If anyone can give me any advise on how to stop a leak please ?
I have just installed a new Fluidmaster 400 float valve bottom entry brass shank.
It is now leaking with a drip from the bottom white plastic washer which fits onto the cistern.
I made sure the rubber washer was put on cone end...